answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2009-03-05 02:13:28

It is just above the oil filter on the front of the engine.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


It is the three wire sensor on the throttle body.



Usually a crankshaft sensor is located on the bellhousing of the transmission


The oil pressure sensor on a 1997 V8 is on the top rear of the engine next to the distributor.


It is located on the block, passenger side near the firewall. It's right above the oil filter.


It is on the top passenger side of the bell housing.


The governor sensor has to do with transmission fluid pressure.


The crank sensor is located on the top of the bell housing on the drivers side.



Look on the back on the transfer case. There should be one wire running from it. That's your speed sensor. -- Blake.


paste this into your browser...i could not get the link box to take.. but this should ansewr the question on the o2 sensor


The engine coolant temperature sensor is the sensor that is screwed into the thermostat housing on the top front of the engine.


The oil pressure sensor is screwed into the rear of the oil cooler, under the intake manifold.


Trouble code P1762 means: Governor pressure sensor offset improper voltage


No diagram is needed. It will be on the top left/right transmission bell housing.



The oil pressure sensor is mounted on the rear of the oil cooler under the intake manifold.


The range sensor is the sensor that tells the computer what gear its in. Its called a transmission range sensor


Pre 1998, it is on the back of the trans/transfer case After 1998, it is the rear axle abs sensor on top of the rear axle.



it is located on the top of the bell houseing at the back of the block


A sensor could be the reason why a 94 Jeep Grand Cherokee Laredo fails to start. The crank position sensor is often the problem. You can try unplugging the sensor for several minutes and then plugging it back in to see if that fixes the problem.


in the valve body which is inside the transmission.


It is inside the transmission, on the passenger side of the valve body.


I have the same problem on my 1995 Jeep Grand Cherokee Laredo 4.0 and was told it's a bad pressure monitor sender that wasn't reading the pressure correctly. I'm not sure if this is correct and I am continuing to look into the problem. MY 4.0 WOULD PEG OUT HIGH AFTER YOU STARTED IT. IT WAS ALWAYS THE SENSOR LOCATED BELOW THE DISTRIBUTER. NOT TOO HARD TO SEE. HAPPENED EVERY COUPLE OF YEARS( 50K-60K MILES)



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.