0
The oil pressure switch will be loated behind your engine when looking at the car from the front. Itll be under the compartment holding your air filter towards the center of the engine itself.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the carburetor in your 1991 Chevy cavilier?
where is thecarburetor in my 1991 Chevy caviler
Does a 1991 Chevy s10 pickup have an inertia switch?
No it does not. Chevy did not use them in that year on there trucks.
Does a 1991 Chevy Camaro have a fuel shut off switch?
No
Where is the Plymouth Voyager oil pressure switch?
In a 1991 3.3l the oil pressure switch is located beside the oil filter
Why does your 1991 Chevy Caviler shake and die when put under a load at low idle?
Not running on all cylinders? Check spark plugs and wires, perhaps do a compression check
How do you replace heater core on 1991 caviler must you remove dash?
no
Where is the fuel safety switch on a 1991 Chevy lumma?
GM vehicles are not equipped with an fuel pump inertia switch.
Where is the fuel pressure regulator on 1991 Chevy s10?
It is in the throttle body.
Where is the coolant temperature switch for a Chevy Corsica?
1991 Corsica its under the trottle body
Fuel pressure 1991 Chevy 2.8 liter?
50 to 60 lbs
Where is front axle actuator switch on 1991 Chevy?
That switch is screewed into the top of the transfur case that's bolted to the rear of the transmission.
Where is the oil pressure switch on a 1991 Chevy silverado?
It is screwed into the top of the engine block right behind the distributor. It is about 3 inches long and laying on it's side with an electrical connector pluged into it. It is hard to get to.
