0
Where is the oil pressure switch located on a 1997 dodge stratus 2.5L V6?
Wiki User
∙ 14y ago
my 99 was located rite above the oil filter. you will need to take the filter off after drain the oil of course and get a special socket to fit it. your local auto parts store can get the rite socket for you.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where does the reset engine firing switch located in a 95 dodge stratus?
Dodge does not have a reset switch.
Where is the dodge stratus 2000 fuel pump switch location?
A Dodge Stratus does not have a reset switch.
What switch is located under gas pedal in a dodge stratus?
There isn't a switch there from the factory.There isn't a switch there from the factory.
Does the 1998 dodge stratus have a low oil pressure switch that cuts the engine off if it's low?
No.
Why is the oil light constantly on with at 1997 dodge stratus?
If the engine is not noisy then you have pressure. The cause is probably a failed oil pressure switch.
Where is the relay switch flasher located on a 99 stratus?
The relay switch flasher on a 99 Dodge Stratus is located in under the dash near the pedals. It can be accessed by removing the outer panel and pulling the flasher from the housing.
Where is the Lr pressure switch in a 99 dodge stratus?
The low reverse pressure switch is part of the solenoid pack. That is the part on the front of the transmission case below the cooler hoses.
Where is the inertia switch on a 2000 dodge stratus?
There is none as your Dodge is not equipped with an inertia switch.
Where is the fuel pump off switch on a 2000 dodge stratus?
A Dodge Stratus does not have an inertia or reset switch. The fuel pump is computer controlled with relays.
Where is the LR pressure switch on a 1996 dodge stratus?
It is in the Solenoid pack, That is the plastic looking part on the front of the transmission case.
Is there a 1995 dodge stratus fuel pump reset switch?
No. A 1995 Dodge does not have a reset switch.
Where is the fuel pump reset button located on a 2002 Dodge Stratus?
Dodge doesn't use an inertia switch. The system is computer controlled with relays.
