answersLogoWhite

0


Best Answer

rear drivers side engine block

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the oil sending unit on a 1988 Chevy Astro Van located?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the power steering fluid located in a Chevy Astro 1988?

under the hood


Does a windshield from a 1993 Chevy Astro van interchange with a 1988 Chevy Astro van?

Yes.


Where is the Temperature sending unit located on a 1988 Chevy 305?

connected to thermostat housing


Where are the fuel lines located?

1988 Chevy corsica fuel sending unit whai have a 1988 Chevy corsica i need to no on the fuel sending unit the bib line goes to what line and the two little lines go where please help


Where is the fuel pump relay on a 1988 Chevy Astro located?

on a 1997 Chevy astro it is in a fuse-relay center - in a plastic box located just to the left of the battery. Take off the top; the schematics of what's what should be on the inside top of the box, as well as in your owner's manual.


Where is the oil pressure sending unit located on a 1988 Chevy s10?

At the rearmost section of the engine to the right of the distributor.


What is the firing order for a 1988 Chevy Astro Van 4.3L?

1.6.5.4.3.2


How do you add power steering fluid on a 1988 Chevy Astro?

You can add power steering fluid to your 1988 Chevy Astro by removing the top to the power steering fluid reservoir. Pour the fluid directly into the reservoir.


Where is the chassis number located on a 1988 astro van?

You can locate the chassis number of a 1988 Astro van on the driver's side door.


What is the spark plug gap for 1988 Chevy astro van 4.3l?

.45


Where is the chassis number on 1988 astro van?

The chassis number of a 1988 Astro van is located on the pillar of the driver's side door jam.


How do you replace a starter on a 1988 Chevy astro van?

Remove the positive cable from your 1988 Chevy Astro battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install the new starter.