Check Your Chevy Dealer, But It Should Be In The Bottom Of The Condensor. It Is A Little Techinacal To Replace, Suggest A Good Shop For This.
The 1995 Chevrolet Monte Carlo cooling fan sensors are located on the firewall, in the engine compartment. The cooling fan sensors will be on the passenger side of the firewall.
Any time you flush out the cooling system you need to bleed the cooling system.
I dont know how to do this
The cooling fan relay switch, on your 2002 Monte Carlo, is located on the back of the fan hub. You will need to open the engine compartment hood in order to see the relay switch.
A coolant flush on a 96 Z34 Chevy Monte Carlo helps greatly with increasing the efficiency of the cooling system. It removes buildup and contaminants from the system.
chevy 2003 monti carlo how to replace a cooling fan assembly
bad thermostat, bad waterpump, plugged radiator, or the cooling system is filthy and needs flushed out.
were is the bcm located on a 2000 monte carlo
There are 2 and they are located on the intake manifold near the thermostat. The 1 with the single wire is for the gauge. The 2 wire is for the cooling fans and the computor. jd
Should be located down by the battery its kind of tight spot is there a diagram or picture of the port?
The low side pressure port for the 1999 Monte Carlo should be on a pipe against the firewall. It is just to the left of the Dipstick.
Drain the water from your 1997 Chevy Monte Carlo cooling system. Remove the water supply hose. Remove the thermostat housing retaining bolts. The thermostat will lift out. Reverse the process to install the new thermostat.