0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why input is voltage and output is current in fet?
The input is a Gate that is essentially infinite impedance, so no current. The output is essentially the resistance between Source and Drain, which controls the current flowing through it.
Is it legal to have your washing machine drain into your sump pump which is connected to the main sewer pipe?
No! Dumping the washer output into the sump is illegal.
What is the output impedance of common source amplifier circuit?
The output impedance of a common source amplifier circuit is typically high. This is because the common source amplifier uses a resistor to provide biasing, which results in a high output impedance. However, this can be mitigated by using a current source instead of a resistor for biasing.
What is the difference of a gully trap drain from a floor drain?
The difference between a gully trap drain and a floor drain is placement. A floor drain is in a floor, a gully trap drain goes on an external wall.
What is a drain auger?
Tool for cleaning out a drain.
Why input is voltage and output is current in fet?
The input is a Gate that is essentially infinite impedance, so no current. The output is essentially the resistance between Source and Drain, which controls the current flowing through it.
How do you calculate the Volumetric efficiency of a hydraulic motor?
Dear friend, Drive the motor through a pump. Supply oil to achieve a given rpm and pressure. Some oil will come out of case drain port and some from the out put port of the motor. Measure the out put flow of the motor and input flow to the motor. out put by input will be the volumetric efficiency ( the loss is case drain ) ( alternatively, case drain and output flow fof the motor can be measured, then output flow divided by the sum of output flow and case drain flow is the efficiency ) Rajeev T G tgr-bw@bw.ltindia.com
What is transmission Gate circuit?
It has 3 inputs. They are source, n gate, p gate and only one output that is drain
Is it legal to have your washing machine drain into your sump pump which is connected to the main sewer pipe?
No! Dumping the washer output into the sump is illegal.
What is the voltage gain of the FET amplifier?
It can be answered in two ways : 1. ratio of output & input voltages [Vout / Vin] i.e Drain voltage(Vds)/Source voltage(Vs). 2. multiplication of trans-conductance & drain resistance .
What attention should be given to surgical drains after a mastectomy?
The surgical drains must be attended to properly; this includes emptying the drain, measuring fluid output, moving clots through the drain, and identifying problems that need attention from the doctor or nurse.
What is the output impedance of common source amplifier circuit?
The output impedance of a common source amplifier circuit is typically high. This is because the common source amplifier uses a resistor to provide biasing, which results in a high output impedance. However, this can be mitigated by using a current source instead of a resistor for biasing.
Your volt meter reads 16 volts at the battery at idle The alternator and voltage regulator have been replaced Do you have a problem?
Alternator Output Voltage RangeGenerally, alternator output voltage is consider OK if it is in the range between 12 1/2 volts to a maximum of 16 volts.Therefore, although the output is at the maximum, you do not seem to have a problem.Usually, if the battery has had a lot of drain, then the alternator output will run at the maximum until the battery is fully charged.
How can you implement c-bicmos using nand gate?
draw its cmos equivalent and give its output to pull up bjt.then draw nmos block of the logic and connect its drain to
Junction field effect transistor biasing?
When the gate is forward biased, the depletion region is lesser and so the majority carriers(electrons)move freely towards the drain from the source producing high output impedance.When the gate is reverse biased,the depletion region increases(especially near the drain forming wedge shaped depletion)and thus the free flow of the electrons is opposed.hence the output current decreases.The out current becomes zero if the voltage given to the gate is maximum.
Are speakers an input are output device?
Output.
Is system unit is input or output?
output
