It is located on the muffler by the moter and looks like a sparkplug with wire attached at the end.
To be specific, my 2000 Durango has 1 upstream oxygen sensor and 1 downstream oxygen sensor. Both are located on the exhaust pipe. The upstream is between the engine and catalytic converter. The downstream is located between the catalytic converter and muffler. - Mick
The oxygen sensor is located in the exhaust system on a 2005 Dodge Durango Hemi 5.7. There is a sensor located before and after the catalytic converter.
The 4.7L 2002 dodge durango has 4 O2 sensors. ref. Chilton's Dodge Durango/Dakota 2001-03 repair manual. page 6-19 (Oxygen sensor - general info and replacement) The upstream oxygen sensor is located before the catalytic converter. The downstream oxygen sensor is located is located after the catalytic converter.
The 2006 Dodge Durango camshaft position sensor is located on the back end of the head. The position sensor should be labeled as such.
Where is a camshaft position senser located on a 2006 Dodge durango/
The vehicle speed sensor is located on the top center of the rear axle.
Where is a camshaft position senser located on a 2006 dodge durango/
In the rear of the drum
There are 2 or 4, they are in the exhaust pipe directly behind the engine.
Dodge did not produce the Durango until 1998. It is located on the bell housing on the right side of the engine where the transmission mounts to the engine
H02S Bank 1 Sensor 3 Heater circuit. This should be the H02S (heated oxygen sensor) located after the catalytic converter. If the wiring looks okay the sensor is probably bad.
The MAP sensor is located on the intake side before the intake manifold.
It is the four wire sensor on the valve body inside the transmission pan.