there are 4 of them. 2 before the catalytic coverter and two after
Gas sensor? Not sure what you mean, could it be a Fuel gauge sensor? Oxygen sensor? Fuel pressure regulator?
In the exhaust manifold or exhaust pipe and is accessible from under the hood
There should be a connector under the car that it plugs into. It then goes to the computor.
how do you change a crankshaft position sensor on a 1999 chevy camaro z28?
On a 1983 porsche 911 sc the oxygen sensor is located on the left side of the car, right before the catalytic converter. Tip: Removing the rear left wheel will make it much easyer to access.
There are two oxygen sensor for Mitsubishi Outlander. Front Oxygen Sensor and Rear Oxygen Sensor
The position of the camshaft sensor on your 1997 Camaro is dependent upon the type of engine in the Camaro. In most cases the camshaft position sensor is on the back of the left-hand cylinder head.
No, it uses speed density the 2.8 v6 camaro uses a MAF sensor.
If the vehicle was built with an oxygen sensor, you will need an oxygen sensor.
It will require a special slotted socket that can only be used for the one purpose. The cost does not justify the means.
That year did not have a crank sensor.
yes they are of the same generation of camaro so it should be interchangeable
It's integrated into the oxygen sensor. Buy a new oxygen sensor and you get a free oxygen sensor heater.
There is no crank sensor on a 1986 camaro z28.. that sensor is in the camaros past 1988 i believe.. but the 1986 carb or fuel injection (tpi) does not have one
Remove the vacuum hose from the oxygen sensor. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.
Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.
No it does not
i think you mean 13 if so and its a v8 it means your left oxygen sensor is bad or the circuit is open broken wire maybe?? if its a in line 6 cylinder its the one oxygen sensor problem. my book startes at 11.
To replace the oxygen sensor disconnect the oxygen sensor electrical connector. Use an oxygen sensor socket to remove the sensor. spray the sensor with penetration oil if it is difficult to loosen. install in reverse.
it is the oxygen sensor afterthe cat conv
That year did not have a MASS AIR FLOW SENSOR / ( MAF )
its around 107 hp, i have a camaro with a 2.8l v6