I had a 1987 Jetta and the oxygen sensor was connected to the down pipe. It is screwed in and there should be a wire leading from it. From the engine compartment you can look near the firewall and follow the exhaust pipes. It should be sticking out midway between the top and bottom bends.
In the exhaust manifold.
The oxygen sensor on a 2004 Volkswagen Jetta is located in the engine area. It is usually encouraged to warm up the engine so as to ease the threads.
Take it to the dealership.... Its real simple take the car jack it up take off the housing cover where the oxygen sensor is at then un plug the sensor, and replace...
The oxygen sensor is in the top center of the rear exhaust manifold.
There are two Oxygen sensors on your car. Both are under the car on the exhaust piping. One is the upstream sensor located closer to the motor and the other is after the catalytic converter.
The Jetta has two oxygen sensors.
oxygen sensor is found either in exhaust manifold or in actual exhaust pipe between manifold and muffler
where is the crankshaft position sensor on 2.5 liter vw jetta
The oxygen sensor is more commonly known as a lambda sensor at it monitors the amount of oxygen in the exhaust gasses going through the exhaust, the Mass air flow meter monitors the incoming air coming through the air intake before it enters the engine.
It is in the exhaust system before the catalytic converter.
The speed sensor in located in the front of the motor. You can find it near the transmission and the engine split line on the Jetta.
not necessarily. just make sure you got the right size wrench... although, there is an oxygen sensor tool specifically for removal and replacing. would make your life easier.
The solenoid electrical sensor is responsible for allowing a shift in gears. The sensor in a Jetta VR6 can be fixed by a dealer mechanic.
Just downstream after the exhaust manifold
You will find the oxygen sensor just after the exhaust manifold and just ahead of the catalytic converter. Get under your car or maybe you can access it from under the hood. It screws right into the exhaust pipe.
The oxygen sensor is usually located on the exhaust system. You should find it just after the exhaust manifold and just ahead of the ctalytic converter...Don the Juan.
The speed sensor on a 98 Jetta is located near the brake setup. It is on the passenger wheel area mounted to a bracket.
There are two oxygen sensor for Mitsubishi Outlander. Front Oxygen Sensor and Rear Oxygen Sensor
If the vehicle was built with an oxygen sensor, you will need an oxygen sensor.
The idle speed sensor tells the onboard computer how fast your engine is idling. The location of the idle speed sensor on the VW Jetta is on the actual throttle body.
It's integrated into the oxygen sensor. Buy a new oxygen sensor and you get a free oxygen sensor heater.
A knock sensor sends a voltage signal to regulate ignition timing. In a Jetta, it is typically located under the air intake manifold.
how to remplace position of oxigen sensor
Crankshaft Position Sensor (CKP Sensor)