Driver's side valve cover top, locate 3/4" hose its on the end that is inserted into the valve cover.
The power of the engine and the maximum speed of the 1977 Buick Skylark manual are 220 hp at 4400 rpm and 250 km/h respectively.
in the valve cover left side and hooked to carb
The Answer is yes! Buick sold the engine tooling to AMC in the late 60's and bought it back around 73 and started to put it in to Buick Apollo's, Skylark's and Century/Regals in 1975.
Any other window from a 1975-79 Buick Skylark, Oldsmobile Omega or Pontiac Ventura/Phoenix 2 door would work
Buick Skyhawk was created in 1975.
Inside the oil pan, mounted on the bottom of the engine block.
Depends on which Buick model you're referring to...
H7815
On a 1975 Buick that has been converted to high energy ignition, the vacuum advance is typically located on the side of the distributor opposite the ignition coil. This positioning allows for proper operation and adjustment of the advance mechanism. However, it's important to check the specific model and setup, as variations can exist.
360 bhp is the power of the Buick riviera coupe 1975 engine and its maximum speed is 125 mph.
On a 1975 Buick Electra, the fuel filter is typically located along the fuel line, often near the fuel tank or between the tank and the carburetor. It may be mounted on the frame or the body of the car, depending on the specific setup. To access it, you might need to lift the vehicle or remove some components for better visibility. Always consult the vehicle's service manual for the exact location and instructions.
The approximate maximum speed of the 1975 Buick le Sabre sedan automatic 8cyl 162hp is 107 mph.