On a 96 with a 3.4L, it is on the driver's side, at the rear of the engine (right at the firewall). If you look close, there is a small rubber tube that comes up the side of the engine. The PCV valve goes into that tube. It's set up like an in-line valve, rather than the traditional "in the valve cover" you're probably used to.
How do i replace the purge valve on a 1999 Chevy Monte Carlo
The low side pressure port for the 1999 Monte Carlo should be on a pipe against the firewall. It is just to the left of the Dipstick.
The transmission modulator valve, On your 2006 Chevrolet Monte Carlo, is located on the top of the transmission. The valve should be labeled as such.
Should be located down by the battery its kind of tight spot is there a diagram or picture of the port?
The PCV valve for a 1998 Monte Carlo should plug into the valve cover. Twist and pull it to remove and replace it.
That is normal. It means it is not stuck.
radiator drain valve is located at the bottom of the radiator, there is an access hole through splash guard.
The shift solenoids are located on the valve body. you can get to it by removing the side cover on the transmission. The side cover is hard to remove. You have to lower the craddle down far enough to get it out. This can be diffucult without it being on a lift but it can be done.
You have to remove the air cleaner box and its right underneath it on the 3.1 liter Monte Carlo ls's You have to remove the air cleaner box and its right underneath it on the 3.1 liter Monte Carlo ls's
Add gsdgc ggdd ff
Back by the gas tank
upper right side back of the motor almost to the right and under the egr valve