Crankcases and PCV Valves
Mercury Villager
Grand Prix GT

Where is the pcv valve on a 97 Mercury Villager van?

293031

Top Answer
User Avatar
Wiki User
2005-09-21 16:41:46
2005-09-21 16:41:46

It's located on the back side of the intake manifold. It's screwed into the manifold.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

You will need to remove the valve cover from your 1995 Mercury Villager. Peel the valve cover gasket off of the valve cover. Clean the valve cover surface. Apply the new valve cover gasket.

User Avatar

What is the fuel tank capacity of a 1997 Mercury Villager van?

User Avatar

on my 1999 ford mercury villager its on top of transmission under the van

User Avatar

Where's the PCV valve located on a 2004 Toyota Sienna van

User Avatar

This is not possible on a modern vehicle like the Villager.

User Avatar

The 3.0 litre V6 engine in a 1998 Mercury Villager has a timing BELT

User Avatar

1995 Mercury Truck Villager Van 3.0L EFI SOHC 6cylThe Spark Plug Gap.032 (In thousandths of an inch)

User Avatar

None, until the Monterey, which was only sold 2004-2007.

User Avatar

It is not repairable, you should replace the instrument cluster.

User Avatar

Need more information. What are you trying to bleed?

User Avatar

You can't fix it till you know what's wrong with it.

User Avatar

Top rear edge of the lower transmission housing.

User Avatar

The 1997 Mercury Villager van has an EPA estimated city/highway mileage of 16 and 21 miles per gallon (mpg). The Villager wagon is also rated at 16/21 mpg.

User Avatar

If you are looking for the location of the PCV valve, check the link to the left of this answer. It is in the upper-left part of the picture, which is the right side of the engine, as you look at it from in front of the van.If you want to know how to replace the PCV valve, just disconnect the vacuum line from the top of the valve and then pull it out.Installation is the reverse of this procedure.Take Care,Greg

User Avatar

All Mercury Villagers have a V-6 engine, there is no 4 cylinder.

User Avatar

O2 sensors are always located on the exhaust system.

User Avatar

To replace lamps the cluster must be removed.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.