answersLogoWhite

0


Best Answer

It is on the bottom of the steering gear box.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the pitman arm on a 1999 suburban?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where are the lub points on a 1999 Chevrolet Suburban?

Upper and lower ball joints (4). Inner and outer tie rod ends (4). Idler arm (2). Pitman arm (1).


Where is idle arm located on a 1999 Chevy S10?

there is an "idler arm", its part of the steering and runs horizontal, as well as a pitman arm


How do you remove the pitman arm on 1950 Chevy truck?

With a pitman arm puller.


How do you fix a leak in the pitman arm of a f 150?

Replace pump / pitman arm


Did sir isaac pitman invent the pitman arm?

No. George Washington Pitman of Lauderdale, Alabama invented the pitman arm while working for a local railroad company.


How do you replace 2000 silverado 4x4 pitman arm?

How do you go about replacing the pitman arm on a 2000 Silverado?


How does the pitman arm work?

The pitman arm is the arm connected to the steering box sector shaft that moves side to side to steer the wheels.


Is idler arm and pitman arm same thing on 2000 astro van?

No, there is a pitman arm on the steering box and two idler arms on the linkage.


What does the pitman arm control on a Lincoln town car?

The pitman arm controls the steering linkage enabling you to steer the vehicle.


Where is the Pitman Arm and Idler Arm on a 1996 Chevy Silverado?

The Pitman arm is attached to the power steering pump, which is connected to your steering shaft, which is the long rod looking thing to the right of the engine, the idler arm is to the left of the pitman arm attached to the fram, it basically looks like a strip of metal bolted to the fram that is connected to your shaft that is also connced to the pitman arm


What connects a pitman arm to the idler arm?

Center link


How do you remove the pitman arm from the 1999 Lincoln town car?

you half to loosen the 33 mm seck bolt, separate the end going into the center link, just give it a good whack then lube the end of the pitman arm with the splines and pray.................................. then install you pitman arm puller and if you prayed hard enough it will pop right off if not you didn't pray had enough then see a a.s.e certified tech