to find your tensioner pulley just follow belt rout the tensioner is always the smallest pulley and the bracket its on look plastic.now if you have a pump that has a belt around it and the crank shaft pulley only then you need to check the pump set up itself sometime parts are set up that you have to loosen bolts to take tension off belts
Remove the 1998 Oldsmobile power steering pump hose. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump.
The Camshaft Position Sensor is located behind the Power Steering Pump.
Begin by loosening the tensioner pulley. Slide the tensioner pulley to the right. The power steering belt will become loose and can be removed. Put the new power steering belt on and tighten it by sliding the tensioner pulley to the left.
There is a diagram, for the power window system, for your 1995 Oldsmobile. The diagram can be obtained from most General Motors dealerships.
how to replace the power steering hose on a 2001 oldsmobile aurora 3.5 liter engine
power steering fluid or ATF III
Loose power steering belt/worn power steering belt/defective belt tensioner.
The power steering in a Pulsar is belt driven. Once you locate the power steering belt under the hood, the tensioner will allow removal.
Loosen the tensioner pulley. Remove the power steering belt. Remove the power steering hose. Remove the power steering retaining bolts. The power steering pump will come off.
it ranges between $90.00 and $120.00 for a new power steering pressure hose, parts and labour, I had 3 estimates done. it takes about an hour for it to be finished depending on how busy the garage is , i got mine parts and labour for $86.98
were is the power steering pressure switch on a 1988 oldsmobile cutlass 2.8 engine
Loosen the tensioner pulley. The power steering belt will come loose. Remove the power steering belt. Reverse the process to install the new power steering belt.