Top Answer
User Avatar
Wiki User
2006-08-21 22:45:23
2006-08-21 22:45:23

It is under the alternator on the back of the engine. Just follow the belt down from the back of the alternator.


Related Questions

you may have to go to a Pontiac dealer for that one.

A 1984 Pontiac Grand Prix comes standard with a 3-speed Turbo-Hydramatic transmission.

Put it in the p/s resirvoir located on the pass side of the engine compartment under the alternator.

how to change steering column on 86 pontiac bonneville

beside the steering wheel on the left side. somewhat under the dash, there should be a handle, if broken..then there will be a wire. you just pull the handle/wire and it opens up the front compartment.

Trouble code P0410 means: Secondary AIR System Performance

the glove box, on the left side theres a little box that opens there in there

The 3.1 does not have a distributor.The 3.1 does not have a distributor.

Where is the power steering resevoir on a 2005 pontiac grand prix?

Where do you add power steering fluid on a 2003 Pontiac Bonneville?

easylook under the hood there is a sticker that shows you how Easy IF the sticker is there

There is no reset just discontect your battery for 10 seconds

where to put power steering in a 2007 Pontiac gran prix

Orpheus filter? I am sorry but I don't think there is any Orpheus filter. I am unsure why Pontiac would want to filter song and poetry.

There is a button on the dash marked trac. PUSH IT/////actually the button is on the center council on my 2004 gt2

under the antifreeze compartment

There is no power steering fluid on Pontiac G5/Cobalts, as they are assisted by an electric motor-as opposed to the conventional hydraulic system.

The ECU is in the engine compartment on a 2002 Pontiac Grand Am. It is the sensor behind the converter.

i have 97 pontiac grandprix gt on the digital screnn is shows low we are not sure what is low at the corner of digital screen range shows low

There is only one fuel pump fuse on a 2001 Pontiac Montana. It can be found in the engine compartment near the firewall at the rear of the compartment.

No, the bolt pattern is different and the Audi wheel's bolt holes will not match up to the grandprix therefore being unable to bolt up to the grand prix's hubs.

Try changing the pcv valve. Also check for blockage on the tube going to it.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.