The wiper control module is located inside the wiper motor assembly.
i think what you are refering to is a blower staying on all the time, if so the blower motor has shorted the control module, you need to replace the blower motor and control module.
What year and model
The ECM (engine control module ) is located on the center of the firewall just above the motor. It's the thing that has a lot of wires going to it.
Controls the application of voltage to the motor to control speed and direction of the motor. If there is a built in charger it would also control the charging process.
It is located under the dash near the blower motor.
The windshield wiper control module is usually in the fuse box located in the engine compartment of most automobiles. Sometimes the windshield wiper control module is located on the firewall next to the windshield wiper motor.
The electronic control module is an embedded system that controls one or more of the electrical systems in a motor vehicle. These are sometimes referred to as the car's computer.
The control module for the blower motor is under the glove box inside the heater box.
in the front side of the wiper motor
Extended Commissioning Motor hope that helps :) or, Engine Control Module.
controls all of the electrical systems not related to the motor
The 2000 Chevrolet Corvette blower motor control module can be found behind the passenger side dashboard. You will need to remove the dashboard in order to access the module.
windshield wiper motor. Or it could be the wiper module. If under the hood, its the motor. The module is usually located inside the car.
on the bottom of the wiper motor. its where the cables plug into
The idle is control by the idle air control motor from outputs from the Engine Control Module.
wiper module.... i know for a fat that the control that controls your wipers and turn signal, its one big module, under steering column. check your wiper motor or blown fuse
how do you change a window motor on a 93 aerostar or can you please tell me how to get the windows down without the motor... my e-mail is firstname.lastname@example.org
On the firewall to the right (when facing the firewall) of the blower motor.
AnswerSince 1996, engine ignition control has been handled by the Powertrain Control Module (PCM).The PCM has direct control over the ignition coils / coilpack (or coil-on-plug on some engines) - so the need for a 'distributor' has gone away.Coilpacks cost about $75Sidebar: without a distributor, the engine timing is also totally handled by the PCM.See "Related Questions" below for information about Ignition Control Modules on 1986-1995 Taurus/Sables.On a 1996 Ford Taurus the ignition control module is part of the drivetrain control module. To change the ignition control module you have to change out the computer. It is located behind the motor on the passenger side of the engine compartment. Look for a screw holding in a wiring plug with a dozen or so wires. The drivetrain control module has a couple of nuts holding it in place and looks like a cdrom when removed. Good luck. John
it is on the side of transfer case looks a little like a wiper motor..
Canada Cycle & Motor company central control module Customer Communications Management
your motor resister is bad or might be called the climate control module
My 2005 does the same thing, just found out it's the blower motor control module. Hope that helps out!!