The easiest way to drain the coolant on a Northstar is to pull the lower radiator hose off. There is a petcock on the lower left (driver side) of the radiator but it's almost impossible to get to without a special tool.
there should be a drain valve located on the passenger side on the bottom of the radiator
Where is the radiator drain plug for a 1995 Cadillac Seville 32valve northstar 4.6litre V8
The radiator drain should be on the bottom of the radiator towards the engine. If the radiator is the one that does not have a drain then the lower hose will have to be disconnected to drain the system.
AnswerLook at the bottom or rear of radiatorThe drain plug is at the bottom of the radiator on the driver's side. There is a valve located on the engine side of the radiator.
There should be a drain at the bottom corner of the radiator on the side facing the engine.
There are 3 drain plugs on the Toyota Tundra V8 engine and radiator. On the radiator petcock, the plastic thumbscrew, and drain valves are on the bottom, driverâ??s side of the radiator.
The easiest way is to pull the lower radiator hose. There is a petcock on the bottom of the radiator, but it's a pain to get to without a special tool. Pop the hose and you'll get about 85% of the coolant out. Have a large drain bucket handy. Make sure the engine is cool.
Most vehicles have a drain on both.
Place something to catch the engine coolant beneath your 1990 Chevy Corsica radiator. Remove the radiator drain plug with a 9/16 ratchet. The engine coolant will drain out.
The drain plug should be at the bottom of the radiator facing the engine. Some Chevys did not have a drain plug, on these models the bottom radiator hose has to be disconnected to drain the system.
Drain off the radiator coolant into a clean drain pan. Loosen radiator hose clamps. Remove radiator hose. Install in reverse order.
Drain at bottom of radiator so you can get antifreeze out.
I take it you are asking about a Dakato etc.? Facing the truck the radiator drain is on the bottom right of the radiator & will be facing toward the engine. There are 2 drain bolts on the engine block-one on each side.
* With the engine cold remove the radiator cap * Move a large container under to catch the coolant as you drain it * Drain the radiator by opening the drain plug at the bottom on the left side
the bottom of the radiator, but it faces the engine...get it? :)
driver'side lower radiator
where the radiator drain on 2003 bettle
Lower right of the rad. sometimes it is easier to drain the rad by removing the lower rad hose.
To drain the radiator in a 2001 Focus, loosen the cap on the top of the radiator overflow tank. Then loosen the lowest radiator hose on the radiator. Drain the antifreeze into a bucket to prevent ground pollution. Be careful, if the engine was recently running. The liquid will be hot.
It is on the inside bottom right corner of the radiator. Towards the engine. It will be a plastic drain cock. It is hard to see, but it is there,
There is a drain valve at the bottom of the radiator and you will have to remove the drain bolt in the engine block.
You can find it at bottom of the radiator, also there is a special drain plug in the engine body.
To clean radiator corrosion, first make sure the radiator is cool. Remove the cap, and place a bucket under the radiator to catch the water. Open the drain cock on the bottom of the radiator. When empty, close the drain cock and pour a coolant flush into the radiator. Top it off with water. Replace radiator cap and run the engine for 10-minutes, with the heater going full blast. Turn the engine off and wait until the engine has cooled off. Drain radiator once more. Then, fill the radiator with a 50/50 mixture of engine coolant and water.
You drain coolant from the radiator. but according to the book ther are two plugs on the engine block that need to drain the coolant from.