Fuel Pumps
Chevy S-10
Chevy Blazer S-10

Where is the reset button located on a 1999 Chevy S-10?

727374

Top Answer
User Avatar
Wiki User
2015-06-07 13:30:22
2015-06-07 13:30:22

If this is the reset "change oil" light, there is a trick mechanics use for this. You turn the ignition key to the second position where the dashboard lights come on, don't start the vehicle, now stomp the pedal to the floor 4 times, on the fourth time hold the pedal to the floor until the light goes off. this works on many newer GM vehicles. Some others have a red reset button in the side of the dash between the door located in the fuse box.

If your looking for a fuel pump reset button, it doesn't have one.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Checrolet does not use inertia/reset switches.

User Avatar

No, a 1999 Dodge does not have a reset button.

User Avatar

Chevrolet does not use inertia/reset switches.Chevrolet does not use inertia/reset switches.

User Avatar

The fuel reset button for a 1999 Mazda 626 is located inside the trunk of the vehicle. It will be on the left side close to the outer left tail light.

User Avatar

No. A 1999 Dodge does not have a reset switch.

User Avatar

There isn't a reset button on that vehicle.

User Avatar

No there is not, Chevy did not use a Inertia or a reset switch on there trucks. You need to check the fuel pump fuse and relay. You may just have a bad fuel pump.

User Avatar

there is no reset button....u can unhook the battery or the fuse located in the fuse box under your left knee when sitting in the driver sit

User Avatar

Chrysler does not have reset switches.

User Avatar

how do you reset the tension on a 1999 Chevy cavalier 2.4 litre

User Avatar

Time with no problems will make the light go out or you can hit the reset button on the test unit. If you have an auto parts store nearby, they will very often do this for you.

User Avatar

where is my hood latch located on my 1999 Chevy silverado pickup

User Avatar

There is a button located near the clutch pedal area up under the dash. It is a black button on a wire near the fuse box.

User Avatar

On my aurora, I just hold in the reset button.............

User Avatar

Dodge does not use inertia/reset switches.

User Avatar

I was looking at the 1999 Lincoln Town Car Owner Guide and it shows : The fuel pump shut off switch ( inertia switch ) with the reset button on top is located in the trunk , on the drivers side , behind the trunk liner * But the drawing shows it is mounted on a bracket by the drivers side trunk lid hinge *

User Avatar

You can reset one by pushing the button down. The inertia switch is located behind the left kick panel on the drivers side.

User Avatar

The only way to completely reset the anti theft system on a 1999 Ford Windstar is to unhook the battery for 45 minutes. Once you hook the battery back up, the anti theft will be reset and any warning lights will be off.

User Avatar

Disconnect the battery for a couple of minutes, that will reset the ECU...


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.