in the trunk, under the carpet to the left side quarterpanel
in this case its ok to push the red button
For the 1994, you have to remove the negative battery cable, then depress the brake and hold it in for 5 seconds to reset the check engine light.
yes....
push the button down
Yessir, it will.
If you are talking about the inertia switch, it is in the hatch on the driver's side under the floor mat behind the wheel well.
hi, i could'nt find the inertia switch on my ford probe 1994 for ages. Eventually I found it just above the wheel arch on passenger side in boot but you have to remove the plastic covering. Not easy to locate. Hope this helps.
Turn the brightness control up. Could be the reset button for the odometer or another switch.
no, the 89-92 engine/transmissions are different from the 93-97 ford probe.
I don't know if your 1993 is the same as the 1996 Ford Probe , but on the 1996 it's under the carpet in the drivers rear of the cargo area , covered by a rubber cap , you push the raised portion of the rubber down to reset the switch ( P.S. close to the taillight )
the fuel pump shut off switch is in the trunk at the back on the drivers side, underneath a carpet/wood cover.
If it's the same as the 1996 Ford Probe , it's in the hatch area - lift the carpet in the drivers rear area of the cargo area , you will see a rubber cap / plug , push the raised area of the plug in order to reset the fuel shut off switch