0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Is there a reset button on 2003 Subaru Outback?
where is black reset button umder drivers dash
How do you reset the oil change light Subaru Outback you?
A person can reset the oil change light on the Subaru Outback by turning off the vehicle and disconnecting the battery. Also, it is important to check the oil level just in case there is an issue.
How do you Reset Auto Door Locks on a 1998 Subaru Outback?
How do you reset the auto locks on a 1998 Subaru. Disconnected the battery to clean terminals. Now the auto lock does not work from the door switches
How do you reset anti-theft system on 2001 Subaru Outback?
The procedure is covered in your owner's manual. If you don't have one you can download a .pdf file.
Where is computer reset button located on a 98 subaru impreza outback?
There is no reset button. Disconnect the battery for a few hours, then reconnect and the computer's memory will be erased. You'll have to reprogram your radio setting.
Where is the ECM reset button on a 1999 Subaru Outback Impreza?
There is no reset button. The computer is reset by repairing whatever tripped the CE light, and then using a scan tool to reset the light. Reset the light without repairing the problem and the light will just come back on.
How do you reset vdc off light in subaru 2001 outback?
Try holding the "VDC off" button down for 10 seconds. Not sure, but worth a try. I think I might reset when you start up again.
How do you reset the security alarm on a 2004 Subaru Outback?
you turn on the car put the parking break on open the door slam in shut with the lock on(you dont need tpo slam) open it up and on the keypad by the handle type in a password and click your key car finder thing
How do you reset 1999 Subaru Outback alarm?
find the reset button under the drivers dash, its atached to two brown wires. once you've found the button turn the key on and hold the button at the same time. this will reset the system and stop the lights from flashing.
Does the Subaru outback have to have the computer reset in the factory?
If you mean the diagnostic computer (the thing that makes the "check engine" light come on), then no - any dealership should be able to reset this, or you can do it yourself if you buy an OBDII hand-held computer (about $35 on Amazon).
How do you reset the check engine light on a 1998 Subaru Outback?
Try disconnecting battery for 10 mins. If light comes back on have vehicle scanned to determine if there is a problem or have codes "cleared"
How do you reset the check engine light on 2005 Subaru Outback?
The best solution would be to borrow an OBD II code reader from Schuck's, plug it in (just below hood release mechanism in 2000 model), note the error code, and clear it by following the instructions on the screen. Alternatively, you can remove an reattach the negative terminal on the battery. This will reset your electrical system though, so it could mess with security systems and you might have to reset your clock.
