I have 1993, but I'm sure its not much different.
to get to the slave cylinder you will need to take out: MAS, Air filter, Y-pipe, maybe battery and other hoses.
check these sites:
www.3si.org
instructions:
http://www.penguinhosting.net/~bigmac/homepage/cars/faqs/slavecylinder/slavecylinder.html
Follow the hydraulic hose from the clutch master cylinder. The other end attaches to the slave cylinder.
Slave cylinder on a 5 speed manual transmission is found standing by the passenger fender looking below the air flow tube.
Mine is a cable clutch so there is no slave cylinder. But if yours is a hydraulic clutch then it should be located on the firewall on the driver side close to the master cylinder.
The clutch slave cylinder in your 1998 Mitsubishi does not use fluid. The clutch slave cylinder is sealed with grease inside of it.
On top of the transmission, near the clutch slave cylinder.
where is the slave cylinder located on a 2004 satern vue
The slave cylinder for your hydraulic clutch is located inside the manual transmission bellhousing
The slave cylinder for a hydraulic clutch is located inside the manual transmission bellhousing
Probably remove the transmissionm if its a internal slave, if external then its mounted on the outside of the tranny. The master clutch cylinder is located on the firewall. Bleed the system and pump the hell out of the clutch after installing the new slave. : On a 99 GST it is an external cylinder (2) 10mm bolts remove the line replace cylinder bleed system.
the slave clutch cylinder is located behind the engine directly above the flywheel on the Transmission
The slave cylinder for your hydraulic clutch is located inside the transmission bell housing
it is located on the side of the transmission