Probably remove the transmissionm if its a internal slave, if external then its mounted on the outside of the tranny. The master clutch cylinder is located on the firewall. Bleed the system and pump the hell out of the clutch after installing the new slave.
On a 99 GST it is an external cylinder (2) 10mm bolts remove the line replace cylinder bleed system.
The clutch slave cylinder in your 1998 Mitsubishi does not use fluid. The clutch slave cylinder is sealed with grease inside of it.
The inner seals have failed. You need a new clutch slave cylinder.
How do you replace a slave cylinder in a 96 chevey k1500
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
How do you replace a slave cylinder on a 1995 dodge neon clutch
how to replace the slave cylinder on a 1993 jeep wrangler
HOW DO YOU REPLACE THE SLAVE CYLINDER ON A 1994 f 250 2 WHEEL DRIVE
you just replace it
to answer your question i need more info such as what type or model car is it and is it a clutch slave cylinder
Remove the transmission to excess the inturnal slave cylinder
Replace the slave cylinder.
Mine is a cable clutch so there is no slave cylinder. But if yours is a hydraulic clutch then it should be located on the firewall on the driver side close to the master cylinder.
The transmission has to be removed to gain access to the clutch slave cylinder.
if i replace slave cylinder in 1994 Honda civic ex will this make my clutch disengage and engage correctlyanswerchange master cylinder and slave properly then bleed the system properly.
The Slave Cylinder and the Master Cylinder control totally different systems. The Slave has to do with the clutch, and the Master has to do with the brakes. They have nothing in common.
No you don't have to drop the transmission in order to replace the slave cylinder, but be careful because it can easily be stripped.
You will have to remove the transmission since the slave cylinder on the 91 yj is inside the bellhousing.
It depends on where the slave cylinder is located. If it is inside the bell housing you will have to remove the transmission.
I'm pretty sure that on that vehicle the slave cylinder is located inside the transmssion which means the transmission must be removed to replace it
The slave cylinder is usually replaced during a clutch replacement. The slave unit is fairly inexpensive but the labor can be costly since most vehicles require the transmission to be removed to replace the slave. Since the transmission has to be removed to replace the clutch anyway, there is no extra labor involved to replace the slave.
The slave cylinder is inside the trans. If you need to replace it you will have to pull the trans out. Its not that bad, its a afternoon though.
By going to a garage
You have to pull the tranny as it is located internally
To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.
first take off slave cylinder, it should be mounted on your frame, then take off hoses, connect hoses to new slave cylinder. mount slave cylinder back to frame and bleed ur clutch for f*****g hours.