its located underneath the passenger side of the truck bolted onto the transmission with a line attatched to it.
It is straight underneath the starter
It is made on to the clutch slave cylinder that mounts on the side of the transmission.
you must remove the clutch slave cylinder and line. Then unbolt the starser and install the new one
It is mounted on the transmission bell housing by 2 bolts. The clutch master cylinder is mounted on the drivers side fire wall.
To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.
How do you replace a slave cylinder in a 96 chevey k1500
Yes you do. It is inside of the bell housing.
you must drive the roll pin out where the line goes into the slave cylinder its a real small pin. can use a small punch or nail to remove.
Inside bell housing. Transmission has to be removed to gain access to the slave cylinder/throw-out bearing.
on the bottom of slave cyl,use Allen key
HOW DO YOU REPLACE THE SLAVE CYLINDER ON A 1994 f 250 2 WHEEL DRIVE
The slave cylinder is actually built onto the throw-out bearing. If you have a problem with it you will have to pull the trans.