above the starter
the stock Toyota gear ratio is 4.11
4wd or 2wd?
The ECM (computer) is located on the passenger side kick panel!
no the body mounts are different
You should remove the positive cable from your 1996 Toyota battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
Get a shop manual for about $18 and it has pictures and everything.
Uder the dash near the steering colmn. It looks like a flasher.
Freeze Out plug, cracked block or waterjacket.
First generation Toyota Tundra and Sequioa rims, ALL Toyota 4Runners (all years, models, trims, and drive trains), ALL Toyota Land Cruiser rims (all years), ALL years Toyota Pickup (NOTE: 4WD MODELS ONLY), and ALL years Toyota Tacomas (NOTE: 4WD MODELS ONLY) Basically any Toyota 6 Lugnut rim will fit, that is if it's a 4wd truck. I dunno much about the 2wd rims and what all fits. Anyways, hope this helps :)
Just follow the positive cable from the battery. It will end at the starter where it fits into the flywheel housing.
Follow the + battery cable
Because your in 4 wheel drive mode? Switch and or linkage out of adjustment. Bad switch. Bad Relay. Grounded circuit.
it is on the lower side of the motor on the passenger side of your vehicle
Here is a web site that I saw that will help you on removing and replacing the starter on a 1999 Toyota 4Runner: http://www.4crawler.com/4x4/CheapTricks/Starter.shtml
Check your local library for a repair manual.
On the 4WD SR5 truck, front brakes are disc, and rear brakes are drum.
where is the pcv valve located 1994 nissan pick up 4wd 2.4l
Courtesy Toyota of Moran City is at 1105 Brashear Avenue. They carry the full line of Toyota cars and trucks. Their number is 985-380-2395. yes yes i am looking for toyota pickup 4x4 1.5 cabin or 4 door i want to buy an F=450 with an engine size of 7.3 not important no I want a 4WD used Toyota Hilux Pickup. Manual.
If it is automatic you will probably find your knee is putting it in 4wd when it knocks against the the hi lo gear lever.
just a Nissan truch,no d21 or 720,the year it is just a1994 Nissan pickup ,2wd or 4wd.
Yes, you do not have to remove the engine.