Most likely the selonoid on the starter motor needs replacing
2001 sl2. 119 exchanged NAPA auto parts
I changed out mine because it finally failed after about 190,000 miles I have a 1992 sl2,It was very easy to do, 2 bolts to remove,and a couple holding the wiring .pfs
starter is located on the firewall side of the engine. Access is easiest from underneath the car
The wire from the battery to the starter does not include a fuse.
Rear of the engine next to the firewall
As with almost ALL modern vehicles, the starter relay/solenoid is attached to and an integral part of the starter MOTOR.
You have to remove that starter through the top of the engine compartment PLEASE BE PATIENT It's not that hard.... but you get dirty because it's in a hard to reach spot. You will neeed to have a range of extentions with the wobble feature or a universal joint.
The minimum rotor thickness for a 1992 Saturn SL2 is .625 inches for the front and .350 inches for the rear if equipped with rear disc brakes.
Yes, there is an alternator fuse for a 1992 Saturn SL2. It is easy to replace and is found in the fuse box of this car.
The crank sensor is behind the starter. Remover the starter at the back of the engine and you will see the sensor