answersLogoWhite

0


Best Answer

Passenger side under the two back cylinders. Two bolts go through the bottom of the starter into the bottom of the block.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the starter located for a 305 Chevy engine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What sensor is located on the passanger side of the engine block near the starter on a 86 Chevy 305?

That is the knock sensor.


What cause your 305 Chevy engine not to start or crank?

Could be a bad battery or starter.


Where is the knock sensor located on a 1998 Chevy 305 v8?

It is located in the side of the engine block close to the starter . it has a single wire connector and it screws into the water jacket. So be careful when you remove it because engine coolant will come out


Where are the intake and exhaust valves located on a 305 Chevy engine?

In the cylinder heads.


Where is the ground wire for a Chevy 305 starter?

The Chevy starter does not have a ground wire, the starter grounds through the starter casing.


Where is Chevy trailblazer coolant temp sensor located?

where is the temperture sensor located on a 2002 chevy trailblazer with a 4200 motor


What do you need to remove before replacing the starter on a 1989 Chevy caprice with a 305 engine?

The battery cable for sure.


How do you change a starter for a 305 Chevy engine?

Disconnect the - battery cable Raise and support vehicle Disconnect wiring at top of starter Remove starter mounting bolts Remove starter


Is a Chevy 2.8 engine a 305?

Is a 2.8 liter engine a 305?


What is the special feature of the Chevy 305 engine?

There is no information on the internet about what the special feature of the Chevy 305 engine is, in fact, the Chevy 305 and 350 are interchangeable, one is just an older model.


How many types of starters are there for a 1983 305 Chevy engine?

Depends on what the 305 is in, a 305 camaro engine needs like a 9 tooth starter because the fly wheel is 12.75 inches in diameter with 50 some teeth. A 305 in a Chevy half ton will have like a ten tooth starter for the 14.25 inch diameter flywheel that has like 60 some teeth. All 305 engines before 1986 are the same they did have different flywheels for what ever Chevy put them in. 1986 and newer 305's had different cranks the flywheel bolts up different on a 1986 305 compared to a 1983 305.


Where is the coolant engine temperature sensor located in a 1986 Chevy Van 305 cubic inch engine?

drivers side of engine block