I need how to wire relay for 1991 ford mustang.
Where is the starter on 2003 ford mustang?
check in the trunk, or under the back seat.
The 1991 Ford Mustang does not have an OBDII port, because OBDII was not standardized in the United States until 1996.
it depends .is you car a V8 or 4cyl.?
yes!! by the starter and put it in!
inside the passenger side kick panel.
below the chassis and towards the back
transmission dipstick and the exhaust manifod,the starter is located on the left hand side of the engine if you are standing in front of the car.
It is located on the blocked above the starter. You must remove the starter to see it.
I had a 1991 Ford Mustang 5.0 L - LX - automatic , and it had 2.73 's
on top of your steering collum.
hellz no, but who can stop the from trying?
it is located in the front of the gas tank
Yes on the passenger side in front of the tranny...the starter is connected to the bell housing witch is what the transmision is connected to...
always follow your battery cables to find the starter, but on a mustang look on the passenger side of motor at the bell housing, remember to change a starter or any electrical repairs , disconnect the positive cable on the battery
I believe it is mounted in the fuse box
What engine ?
It is located on the passenger side of the motor, on the bottom, right by where the tranny and motor come together. Hope this helps
No , the 5.0 liter High Output V8 engine in a 1991 Ford Mustang GT has a timing CHAIN
I don't know if it is the same as the Ford Mustang , but the BAP sensor was mounted on the firewall - good luck
It's right on the hand side of the motor, under the distributor.
It is located on the passenger side fender firewall behind the battery.
On my ( 1991 ) Ford Mustang 5.0 liter the spark plug gap was ( .054 inch ) What year of Ford Mustang ?
In a 1991 Ford Mustang : The 5.0 liter V8 is rated at ( 225 horsepower from the factory )