Auto Parts and Repairs
Starters and Ignition Systems
Chevy Suburban
Chevy Tahoe

Where is the starter located on a 89 Toyota Corolla 16 valve 2bbl?

313233

Top Answer
User Avatar
Wiki User
2007-01-12 20:44:01
2007-01-12 20:44:01

the starter is on the backside next to the firewall

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The PCV valve on a 1998 Toyota Corolla is located on top of the engine, on the passenger side. It connects the intake manifold with the valve cover.

User Avatar

The PCV valve on a 1987 Toyota Corolla FX16 is located behind the alternator. It is under the intake manifold.

User Avatar

it should be rigth of the valve cover follow the thick vacum hoses from the intake manifold

User Avatar

In the 2001 Toyota Corolla the evap purge solenoid valve is located near the underside of the air cleaner. This is an emissions control device.

User Avatar

what isa the valve adjustment of a 4A engine toyota corolla

User Avatar

according to the emissions label it does not have an EGR valve.

User Avatar

16 valve and double overhead cams

User Avatar

Remove the heater control valve and replace it.

User Avatar

Go to Autozone's web site and look in their part locater.

User Avatar

back of the valve cover-passenger side i believe-it has a vacuum line running to the intake.

User Avatar

The PCV valve is located on top of the valve cover in the middle.

User Avatar

Check the emission label usually located on the top of the radiator or on the core support just in front of the radiator. You will see a diagram of all the vacuum lines and emissions equipment. Generally-the EGR valve is located near the throttle body.

User Avatar

The EGR Valve on a 2006 Corolla is located on the driver's side of the motor at the very top of the valve cover. Look for a disk shaped valve that kind of looks like a flying saucer. It has two small hoses coming off of it that are connected to the EGR Valve Modulator.

User Avatar

To change coolant on a Toyota Corolla, place a bucket under the radiator. Open the radiator drain valve and remove the radiator cap. When all antifreeze drains out, close the drain valve. Then refill with fresh antifreeze and replace the radiator cap.

User Avatar

the evap vent valve is located on the top of the fuel tank. the valve can only be serviced with the fuel tank removed from the vehicle. if you look under the rear of your vehicle in the trunk area you will see a black hose that looks like a household vacuum hose. that hose leads to the top of the to to the vent valve.

User Avatar

next to the evaporator core, under the dash. Access it through the passenger footwell

User Avatar

The PCV valve on a 1997 Toyota Avalon is located on top of the engine. It connects the left valve cover with the intake.

User Avatar

Hey Jennifer==It would help if you included the engine you have but according to my information it parobablyis at the front of the engine in the valve cover. GoodluckJoe The oil cap is on the valve cover, might be tight and remember to give the threads a wipe before re-installing after oil addition. It is located right at the front left side of your Toyota corolla car's bonnet, near to carburetor.

User Avatar

The PCV valve is usually on top of one of the valve covers.

User Avatar

Get a manial on your car. It will keep you from making mistakes

User Avatar

The Geo Prism and Toyota Corolla were assembled in the same factory on the same assembly line using the same engines. The EGR valves should be virtually identical.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.