Where is the starter on a 1994 Taurus 3.8 and how do you replace it?
Follow the cable from the solonlid to the starter and simply take the bolts out and remove it. once you find the starter there will be 3 bolts one on the passenger side 15mm one on the driver side 13 mm and on the driver side there will be a 13 mm nut holding on a ground wire remove the nut and then remove the 13mm stud disconnect the 2 wires connected to the solenoid 1 spade connector and 1 10 mm i think pull the starter to the left and slide it over the front crossmember.
here are the steps to remove your starter Disarm radio coded theft protection as outlined in Technician Safety Information . Disconnect battery ground cable. Raise and support vehicle. Disconnect starter motor electrical connectors. Remove starter motor bolts and starter motor from vehicle. Reverse procedure to install, noting the following: Torque starter motor attaching bolts to 28 - 38 ft.lb.