Wiki User
∙ 2005-11-09 02:12:06For the factory 7 pin wiring harnes, the brake controller wire is located behind the left (drivers side) kick panel by the floor panel. It has a small white tag labeled "brake". You may have to fish around a little bit to locate it, but it is there.
Wiki User
∙ 2005-11-09 02:12:06To connect any controller to a PS3 first plug in a USB cable to the controller. Connect this cable to the PS3 you want to connect the controller to. Press the PS button and the controller will connect.
etrailer.com/faq_cbc.aspx
Refer to your service and user manual to connect your controller to your XBOX 360.
Even if the battery is low connecting the USB controller cable should allow the controller to connect when you press the PS3 emblem on the controller. Without another controller you can not tell if the PS3 or controller is the problem and does not work
for the xbox you need a controller. for xbox connect you don't need a controller.
press Connect on the controller then FC1 on the receiver and it will connect (providing u have plugged the receiver in and turned your ps2 on
You need to press the connect button on the dongle and then press the menu button on the controller
When turning on your controller, it will try and find your Xbox. This will only take 2 seconds around. If you controller takes more time to connect, this could be a controller issue.
The simple answer is you cannot connect a wireless controller to a PC with just the recharge kit, you will need to buy a wireless controller dongle, or a wired controller if you wish to use an Xbox 360 controller on you PC.
To reset a PS3 controller to a different PS3 connect the controller to the PS3 you want to connect it to with a charge cable. Press the PS button and wait for it to connect to the new console. After it connects your controller will now work with the new PS3.
The Xbox 360 controller uses a proprietary wireless technology to connect to the Xbox 360 console.
You need an electric fence controller, first off. The purpose of an electric fence is to scare whatever touches it into staying away. If you try to make one by wiring it to mains power, you will just kill whatever touches it. You can get a controller at Tractor Supply Co. After procuring a controller, running an electric fence is a simple matter of stringing wire on insulated posts. You connect the controller to your fence and ground, and there you have it. Talk to the salesperson at the Tractor Supply store. They will have controllers, wire, insulators, posts that can be easily installed, gate handles, and whatever else you need.