0
Where is the temperature sending unit located on a 2005 Pontiac Bonneville se?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the oil sending unit located on 1981 Pontiac Bonneville 265 engine?
The oil sending unit is located on the 1981 Pontiac Bonneville 265 engine is located on the Starter Disable Kit.
Where is the oil pressure sending unit located on a 2003 pontiac bonneville?
It's located by the oil filter
Where is the temperature sending unit sensor on a Pontiac 2006 g6?
Where is the temperature sending unit located on a 2006 Pontiac g6
2000 Pontiac Bonneville fuel gauge malfunction where is the sending unit located on this vehicle?
Sending unit is in the gas tank attached to the fuel pump as an assembly.
Where is the oil sending unit on a 2000 Pontiac Bonneville and how to replace it?
where is the oil sending unit on my 2000 bonnieville
Where is coolant temperature sending unit located for 1995 Pontiac firebird formula?
located on left side of water pump
1995 Pontiac Bonneville sse and the fan constently runs?
bad relay or temp sending unit
Where is the gas sending unit on a 1997 Bonneville?
The gas gauge sending unit would be located in the fuel tank.
Where is the oil sending unit on a 91 Pontiac Bonneville?
This is a vertical unit directly behind the water pump on the passenger side of the motor.
Where is the oil pressure gage on the 1989 Pontiac Bonneville?
the guage should be located in your dash next to the speedometer, but if you are reffering to the pressure sending unit it is located on passenger side, behind the powersteering pull best accessed for wheel well or from below the car
Where is the oil sending unit on a 1996 Pontiac Bonneville?
behind the power steering unit on the oil pump housing above the oil filter
Where is the oil sending unit located on a 1993 Pontiac Bonneville?
The oil sending unit for a 1993 Bonnivlle is located just above the oil filter towards the firewall( just above the passenger side drive axle). I broke mine with a pry bar when replacing the CV joints and had to replace it. Hope this help....Craig.
