0
Where is the tensioner pulley located on a 1994 Dodge grand caravan?
Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the tensioner pulley on Dodge Caravan 98?
its on the left side. its the easyest pully to see.
Can you take the tensioner pulley off without taking the tensioner off with it on a Dodge Grand Caravan 2000?
Yes, on a 3.3 or 3.8 the serpentine belt pulley does come off the tensioner arm but the bolt is left thread not right handed.
What do you do if a 1995 dodge caravan tensioner pulley doesnt spring back?
The tension spring is broken, and the entire assembly must be replaced.
Where is the idler tensioner pulley on a 98 dodge Dakota?
The 1998 Dodge Dakota tensioner pulley will be the top pulley on the left-hand side of the engine. The tensioner pulley will be able to slide back and forth.
How do you put a pulley on a tensioner in a 1998 dodge caravan?
You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.
What size is the bolt for tensioner pully on 1999 dodge caravan?
It should be a 16mm on the front, to release and put tension on. To remove the tensioner pulley completely, I believe the nut that holds it on from behind is a 15mm.
What do you call the little pulley on a dodge hemi that is below and to the right of the tensioner pulley?
the idler pulley.
How do you replace tensioner pulley on 2000 dodge grand caravan with 3.0 engine?
You unbolt the old one (one bolt) then fit new. Now refit the belt.
How do you adjust the tensioner on a 2000 Dodge Grand Caravan?
You cannot adjust the belt tension on a 2000 dodge grand caravan. This vehicle is equipped with an automatic tensioner. If tensioner is frozen or will not hold the belt tight, it must be replaced.
How do you change the serpentine belt on a Dodge Caravan?
What you need is a ratchet 15mm socket. Losen the idler then slide off the serpentine belt off. There should be a diagram for routing the belt if not draw a diagram before removing it. Replace the serpentine belt crank it 2 or 3 times but don't start the engine. The 4th time start the engine this time the as the engine is idling eyeball the belt agaisnt the tensioner idler and crank pulley make sure the serpentine is algined. A Note: Make sure that you have identified the tensioner pulley as apposed to the idler pulley. With the 15mm socket on the tensioner pulley's bolt, rotate it clockwise and this will release the tension on the belt, or in the case of installing a new serpentine belt, allow you to get it where it belongs. This is the case on my 1997 Dodge Caravan, and probably other year makes. Best of luck- Bryan 1993 Dodge Grand Caravan: Rotating the tensioner pulley's bolt clockwise was the way to replace my belt. By the way, the tensioner pulley in my van was one of the smaller ones in the middle of the whole system, attached to a silver arm coming off the tensioner. Good luck...
Can you tighten the serpentine belt on a 2000 dodge caravan?
You can do that by replacing the tensioner
Where is the tensioner pulley on a 1994 dodge shadow 2.5 Ryan?
There is only 2 tensioner pulley on a Dodge Shadow 2.5L and that's right above the belt that drives the water pump and alternator... that tensioner pulley opperates the AC Compresser and the other one goes for the timing belt.
