answersLogoWhite

0


Best Answer

Follow the top radiator hose down to the water outlet; the stat is in water outlet. Remove air cleaner if it is in the way. I don't drain the rad I just remove the 2-3 bolts holding water outlet in place; coolant will drain the level you need to work at. The outlet may be snug after bolts are removed, nudge it to free outlet cover. Remove cover, old gasket, and stat. Clean sufaces and dry them.Apply a sealer to gasket and install the stat with point facing same direction as old one was. Snug the bolts evenly; do not overtighen them or the housing may crack. Fill with coolant and leave cap off and start car and run for 20 minutes to bleed air out of system. Done. I hope this helps you. Mark

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the thermostat located and how do you replace it located on a 2002 Chevy Impala V6?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the thermostat located on a 2011 Chevy Impala?

weher thermostat locaked for impala 2001


How do you replace the thermostat located on a 1994 Chevy Impala?

The thermostat is located in the thermostat housing at the engine end of the top radiator hose.


How do you replace the thermostat on 2004 3.4 liter Chevy impala?

It is at the engine end of the top radiator hose.The housing is the thermostat housing and the thermostat is located therein.


How do you replace the thermostat on a 2010 Chevy Impala 3.5?

You can replace the thermostat on your 2010 Chevy Impala 3.5 by removing the water hose and the 3 bolts from the thermostat housing. The thermostat will come right out. Reverse the process to install the new thermostat.


How do you remove and change a 2005 Chevy impala thermostat?

The thermostat is located in the housing and the engine end of the top radiator hose. Remove the 2 bolts and replace the thermostat.


Where is the thermostat located on a 2008 Chevy Impala 3.5 v-6?

The engine thermostat, on a 2008 Chevy Impala 3.5 V6, is located on the lower front side of the engine. The thermostat will have a water hose going into the top of it.


02 Chevy impala 3.4 eng PO128 code what do you need to replace?

thermostat


Where is the temperature sensor located in a 2002 Chevy Impala?

It is located on the intake manifold near the thermostat housing.


How do you change a thermostat on a 2004 Chevy impala with a 3.8 liter engine And where is it located?

The thermostat is located in the housing at the engine end of the top radiator hose.


Where is the thermostat located on a 2002 Chevy Impala?

it is located under the throttlebody just follow the upper radiator hose


Image of where thermostat is located on 2006 Chevy impala?

On the 2006 Chevy Impala, the thermostat is located in the hose that is directly above the middle cylinder. It is on the driver's side of the engine compartment right behind the alternator. Look for a long hose that goes from the radiator to that location.


How do replace thermostat on 2004 Chevy Impala?

Partially drain the radiator down . Remove the upper radiator hose at the engine end. The housing is where the thermostat is located. Remove the two bolts and clean Both surfaces. Install the new thermostat.