The thermostat is well hidden at the base of the vee sat next to the oil cooler about 2 hours of stripping down the manifold and trumpets and finally its there. You will have 2 bolts holding it in then you need to follow the pipe and disconnect the hose that goes to the top of the radiator. then you will need to remove the bolt that keeps the dipstick on the block together with bracket moving the Power Steering fluid reservoir(just pull it to one side), then apply heat to break the o ring seal then replace. This job is not for the faint hearted or unskilled diy!! Quotes at a vx dealer will be astronomical so do shop around. expect to pay £350 plus!! GOOD LUCK!! The thermostat is well hidden at the base of the vee sat next to the oil cooler about 2 hours of stripping down the manifold and trumpets and finally its there. You will have 2 bolts holding it in then you need to follow the pipe and disconnect the hose that goes to the top of the radiator. then you will need to remove the bolt that keeps the dipstick on the block together with bracket moving the power steering fluid reservoir(just pull it to one side), then apply heat to break the o ring seal then replace. This job is not for the faint hearted or unskilled diy!! Quotes at a vx dealer will be astronomical so do shop around. expect to pay £350 plus!! GOOD LUCK!!
Alpha Gamma Omega was created on 1927-02-25.
how do you replace a thermostat in a rover 25
Omega Delta Phi was created on 1987-11-25.
The thermostat is located in the lower radiator hose. Unhook the hose from the engine and it is right inside the hose. Be careful to line it up right when you put new one back in. Also the thermostat is one of the more expensive ones out there I paid 25$ for mine at V I P.
where is it to start with.
Omega.
MegaMan Star Force - 2007 Battleship Omega 1-13 was released on: USA: 25 June 2007
Removal Procedure:Remove the air cleaner and duct assembly.Drain the coolant until the coolant level is below the thermostat.Remove the crossover exhaust pipe.Remove the radiator hose from the thermostat housing.Remove the thermostat housing bolts and clean any sealer from the bolt threads.Remove the thermostat housing and gasket.Remove the thermostat.Clean the mating surfaces.Installation Procedure: Install the ThermastatInstall the thermostat housing and gasket.Install the thermostat housing bolts. TightenTighten the bolts to 25 N·m (18 lb ft).Install the radiator hose to the thermostat housing.Install the crossover exhaust pipe.Install the air cleaner and duct assembly.Fill the cooling system.
$25-$50. These were inexpensive evolvers of indifferent quality.
25-50 USD or so
25 30 fps
Around 20 degrees celcius to 25 degrees celcius.