answersLogoWhite

0


Best Answer
Copy

It is in the water outlet on the firewall side of the motor. Find someone with small hands and patience. It has three bolts on the fitting and a gasket and is very difficult to get lined up properly so it won't leak. Finally got it though on the 2nd try.

User Avatar

Wiki User

โˆ™ 2004-11-24 13:24:06
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Where is the thermostat on 1993 Nissan Sentra with a 1.6L engine?
Write your answer...
Submit

Related Questions

What size engine does a 1993 Nissan Sentra ex have?

1.6


Where is starter located in a 1993 Nissan Sentra?

AnswerWhere can i find a diagram to locate where the starter is on a 1993 Nissan Sentra automatic


Where are the thermostat and the water pump in a 1993 Nissan Sentra 5-MT 1.6L and how hard is it to change the water pump?

where is the location of a water pump on a 1993 Nissan maxium located


How do you replace the CV joints on a 1993 Nissan Sentra XE?

How do you replace the CV joints on a 1993 Nissan Sentra XE?"


Engine horse power in 1.6 Nissan Sentra year 1993 has with out any modification?

110hp


Where is Diagram for 1993 Nissan pickup thermostat?

Need to know your engine size in order to anwer your thermostat problems.


What engine will swap with infiniti g20?

I replaced the motor in my 1993 G20 with a motor from a Nissan Sentra from Japan.


Where is the Fuel Pump located on a 1993 Nissan Sentra with a 1.6 Engine?

Mounted on top and inside the fuel tank.


1993 Nissan Sentra autmatic transmission?

I have a 1993 Nissan Sentra. It jerks in first gear. While changing to 2 - 4, it runs very smoothly.


What is the firing order for a 1993 Nissan Sentra?

1342


1993 Nissan sentra cruise control switch goes on but will not engage?

Check the vacuum hose that feeds into the cruise module in the engine.


Which side is the firewall side on a 1993 Nissan Sentra 1.6L engine?

The firewall is the partition between the engine compartment and the cabin, you are looking for the side of the engine that faces the firewall or windshield.


Will 1992 or a 1993 Nissan Sentra transmissions work in a 1994 Nissan Sentra?

yes the trans is the same in all 91-94 for the 1.6L motor


Where is the PCV valve on a 1993 Nissan Sentra?

PCV VALVE - Under hood, center, upper engine area, mounted in intake manifold


How do you fix a rusted out cross member in a 1993 Nissan Sentra?

Replace


Where is the brake light switch located on a 1993 Nissan Sentra?

The brake light switch is located above the brake pedal on a 1993 Nissan Sentra. To reach the switch the driver's door needs to be opened.


Do you need to replace the upper chain guide on a 1993 Nissan Sentra?

How do you adjust timing chain on a 1990 sentra?


Where is oil sending unit located on a 1993 Nissan sentra?

The 1993 Nissan oil sending unit is located on the bottom of the engine inside of the oil pan. You will need to remove the oil pan in order to view the sending unit.


Where is the thermostat located on a 1993 Nissan 300ZX?

the main hose coming off the top of the radiator were it goes int0 the engine.


What is wrong with a 1993 Nissan sentra that has oil on the engine?

More than likely you have a valve cover leak. You probably need to replace the gasket(s).


What parts does a Nissan Sentra 1993 and a Nissan Sentra 1988 share so you can use one for parts?

none of the parts well interchange at all.. except for nuts and bolts.


How do you change the thermostat on a 1993 Nissan Quest?

Follow the lower hose from rediator to engine. The hose is connected to the thermostat at the engine. Remove the hose,(collect fluid) take out the two bolts, remove the thermostat and clean the old gasket off the engine. Use blue gasket seal and install the new thermostat.


What is the thermostat range for a 1993 Nissan truck?

180 degrees


How do you set cam timing on a Nissan Sentra 160 1993 model?

Go to a car dealer for that car you have Nissan and ask them.


Were is a thermostat located on a Nissan Micra 1993?

follow top rad hose into engine remove the 3 bolt housing and ul see it