0
Where is the thermostat on a 1989 Oldsmobile cutlass ciera 3.3 motor v6?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Oldsmobile cutlass ciera window lift motor?
The Oldsmobile Cutlass Cierra window lift motor is located inside of the door. Each window is equipped with a window lift motor.
Will a 1986 Oldsmobile 98 3.8 liter motor fit in a 1993 Oldsmobile cutlass ciera s?
Yes
Where is the thermostat located on a 1987 Cutlass Ciera?
just follow the top radiater hose to it, it's almost always on top of the motor block.
How to change the heater blower motor on a 1988 Oldsmobile cutlass ciera?
It's on the firewall up high on the passenger side. You may need to remove the alternator to get it out.
Does a 1996 Oldsmobile cutlass ciera with a 3.1 motor interchange with a 1995 Oldsmobile cutlass supreme 3.1 motor?
The 2.8, 3.1 and 3.4 are all the same block throughout all years. The only thing that really changed was the style of head, the intake, and a roller camshaft. It should be a direct swap for what you are wanting to do however.
Is the 1979 Oldsmobile cutlass motor the same as the 1985 Oldsmobile's motor?
Depends on which motor you're referring to
Can you put any oldsmobile motor into a 1985 cutlass supreme?
No you can not put any Oldsmobile motor into a 1985 Cutlass Supreme. Each car has a motor that was designed specifically for that vehicle. So if you need to replace the motor in a 1985 Cutlass Supreme, you need to find the specific motor for that vehicle.
Is it bad for the motor in a 96 cutlass ciera to use high mileage 5w30?
Can you use it for What?
How do you change the thermostat on a 1994 Oldsmobile Cutlass Ciera S?
The thermostat for a 94 cutlass ciera s is located on the top driver side of the motor trace the top radiator hose to the motor and there is a housing their for the thermostat. Now the hard part, there are 2 bolts (13mm) holding the housing on, the top one is easy. The bottom one you wiil need a LONG 13mm open end wrench, then very slowly being able to only move the bolt about 1/8th inch at a time you remove the bolt and wiggle and wobble the housing off and remove thermostat then put new one in, the thermostat has a rubber seal around it so there is no need for a gasket, the thermostat sets into a slight recess in the block so that the seal sets flush with the engine block. Rebolt housing and that's it . GOOD LUCK!
If a1987 Oldsmobile cutlass 5.0 what size would the motor be?
307 c.i.
Can a 350 Chevy motor fit in an Oldsmobile cutlass?
Depends on the year and bodystyle
88 Cutlass Ciera electric fan won't turn on at all what could be the cause?
Motor is probably burnt out
