The Electronic Control Module (computer) on a 1989 Jeep Wrangler is house in a metal case on the firewall. It is on the passenger side of the engine compartment.
I know on my vortec engine the valve cover bolts are in the center of the cover and there is only 4, my racecar has vortec heads and my truck has standard stock heads with four bolts on thew corners
With enough time and money any engine would fit.
Yes, but you will also need the wiring harness and ecm.
The engine will physically fit, however the wiring and electronics will not hook up, they are quite different, as is the fuel system.
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
No. A Jeep Wrangler does not have an inertia switch.
No. A 2009 Wrangler and a 1989 Wrangler have a different bolt pattern.
The engine holds six quarts.
Yes but the bolt patter is different so you will have to find an adaptor. Read below
The correct factory tire size for a 1989 Jeep Wrangler is 205/75/15.
no they are a different bolt pattern
No, different bolt pattern.
Yes those are the same model of wrangler, the top will fit just fine.
A 1989 Jeep Wrangler needs 6 quarts of oil for an oil change.
It controls all aspects of the engine, alternator, air conditioning, cruise control.
The fuel pump on a Jeep Wrangler is inside the fuel tank.
follow the bottom hose on the radiator to where it connects to the engine. Inside that connector is the where the thermostat goes. make sure you use some RTV gasket sealer for reassembly.
If you have the 4.2, it is on the passenger side of the engine near where the dipstick enters the block, forward of the starter.
The tops will not fit without modification