Answer If you are looking for the connection that must be dis-connected prior to setting the timing. Then you must open the glove compartment and find a grouping of taped wires behind the compartment. with-in this grouping of wire, look carefully; there is a small portion that can remove the tape then you will see a two wire (I think brown and white) with a connector. Disconnect, set the timing and then reconnect. What I think this does is, advances the timing to computer set. IT'S A SINGLE WIRE THAT IS LT BROWN W/A WHITE TRACE=====I don't believe there is a timing connector to put the vehicle into bypass mode on this year,on the older models yes,but this one I believe is pre-set and the timing can only be set by using a link,like a programmer,but you would be better off asking a garage to be sure
We’re are the wire located for set timing Chevy truck 1996
It does not have one. The timing is controlled by the computer. You must have a OBDII engine scanner to adjust the timing. If you did not have the distributor out are move it then there is no reason to adjust the timing. It is done automatically by the computer.
at what mileage do you change a 99 Chevy Tahoe timing chain.
The 2003 Chevy Tahoe (both the 4.8 and 5.3L engines) have a timing chain, not a belt.
Chevy Tahoe Ignition Key Starter Switch
chain
How do you set timing on 1988-1995 Chevy Tahoe moters 5.7l?
It has a timing chain and gears. NO timing belt.
It has a timing chain.
It has a timing chain and gears. NO BELT.
NO......
The engine in that vehicle doesn't have a timing belt.
It has timing chain and gears. NO belt.