when facing the gear , you will see on the cyl head a big arrow , on the right hand side , it looks like a moulding bit , , but look hard and you will see it ,
fuse box in the engine bay
45 Litres.
The timing marks on a 1993 Geo Metro are located on the on the camshaft and crankshaft sprockets. They must be aligned together to ensure proper initial timing.
The 1993 Hyundai ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
To make the engine run richer
torque settings are 35-60-73
All Hyundai Elantras from 1993 to 2008 use a timing belt instead of a chain as some vehicles do.
the timing belt tensioner is located on the lower side of the rear head just below the camshaft drives
Your timing belt could have went out, not as a result of the additive necessarily, and damaged the valves. Some Hyundais from this time had interference engines that resulted in valve damage when the timing belt broke. This very well could be your issue. Hope it helps.
Fuse box inside car at left front kick panel (by your left foot) Fuse #17---10amps
On a 1993 Ford F-150 : The 4.9 litre / 300 cubic inch inline six cylinder doesn't have a timing chain It has a large gear on the end of the camshaft that meshes with a small gear on the end of the crankshaft
The camshaft sensor on a 1993 Pontiac Grand Am is located behind the rear bearing cap. It detects the position of the camshaft as it rotates and relays this information to the computer.