Chevy Camaro
Chevy Monte Carlo
Turn Signals and Hazard Lights

Where is the turn signal flasher located on a 2003 Monte Carlo SS?

8910

Top Answer
User Avatar
Wiki User
Answered
2009-02-02 01:59:21
2009-02-02 01:59:21

The turn signal/hazard flasher is integrated into the flasher switch. A very common failure on these cars.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


There is no such car as a 1989 Monte Carlo

The 2001 Monte Carlo emergency flasher relay switch and the turn signal flasher relay switch are the same. The flasher relay switch simply plugs in and out.

The 2002 Monte Carlo blinker flasher relay switch is located beneath the drivers side dashboard. The blinker flasher relay switch will be above the brake pedal.

Above the radio there is a button with red triangles on it. That is where the turn signal flasher is. You have to take the dash off to get to it.

you probably need a new turn signal flasher .

In all likelihood, in a relay box, under the hood. Failing that, it ought to be in the fuse panel, inside the car.

it should be located in one of your fuze panals

The flasher that works the front turn signals also work the rear.

The flasher relay switch is located beneath the dashboard, on the drivers side. The flasher handle is located on the left hand side of the steering column.

The turn signal flasher on a 2001 Monte Carlo is behind the hazard button on the instrument panel. You have to take out the instrument panel bezel to access it. I found this out through a Haynes repair manual for that car. I have to replace mine and did some research. The turn signals and hazard lights are both tied into the same flasher. Hope this helps.

Check for a blown fuse. If the fuse if OK, replace the Flasher Relay.

where is my singnals and hazard flalsher on my 2004 Chevy Monte Carlo

were is the bcm located on a 2000 monte carlo

The Monte uses a single flasher unit that integrates turn signal and flasher functions. It is mounted in a junction block that is attached to the firewall just to the left of the steering column under the instrument panel. To get at it you have to remove the the sound insulation panel that is attached to the lower steering cover and then the lower steering cover as well.

I hunted and hunted a couple years ago for the signal flasher for my 1996 Monte Carlo. At the factory for some reason, it is hidden at the left side of the steering column where it enters the cars firewall. I can't take credit for find it. I was talking to a counter salesman at Auto Zone about not being able to find the signal flasher. He walked out to my Monte and went directly to the above location and pulled it out from the hidding place. The signal flasher was good. My problem with the turn signals not flashing was the button that is pushed down to activate the emergency flashers. I removed the button which was loose in the factory hole and used a pair of needle nose pliars to pull up on the switch where the button was. Signals working again. I think the installers of a recent new turn signal switch at GM Chevrolet dealership messed it up I installed the turn signal flasher in the approiate location, the location where it should of been when my Monte Carlo left the factory. The mounting squeese pin on on back of the turn signal flasher and it fits the hole for mounting just fine.

There is no flasher. It is part of the Hazzard switch assembly. Luckily mine went out under warranty. You need to remove most of the dash to get to the part. I think the switch alone was about $70. The Impala's had a recall on this part, but not the Monte Carlos, go figure.

THE FLASHER ON THE MONTE IS UNDER THE DASH ON THE DRIVER'S SIDE. IT WILL BE NEAR THE CENTER, BUT STILL ON THE DRIVERS SIDE. under the dash on the drivers side. just left of the steering colum. Its a little black box with white lettering on it. Its about a 1"x1" box.

where is the vaccum canister located on a 96 monte carlo

http://wiki.answers.com/Q/Replacing_a_rear_light_bulb_on_a_1999_monte_carlo_where_do_you_go_to_access_the_rear_right_light

The flasher is an integrated module for both turn signals and emerg. flashers. It is located in a junction block that is mounted on the firewall to the left of the steering column under the instrument panel. You have to remove the sound insulator panel and the lower steering column cover to get at it.

where is the oil pressure switch located on a 2004 monte carlo

Check bulb (double filamented smaller for turn signal larger for parking/tailight) Check socket for corrosion Replace turn signal flasher or check ur hazard light button i had the same problem


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.