Air Conditioning and Coolant
Chevy Silverado

Where is the valve or port to add freon to a 2000 Chevy Silverado truck?

456

Top Answer
User Avatar
Wiki User
Answered
2014-10-07 02:15:15
2014-10-07 02:15:15

The 2000 Chevrolet Silverado truck has two ports on top of the air conditioner compressor. You will add Freon through the low pressure port.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


The schrader valve on the low pressure side of the system.



On the 2007 Chevy, it is by the gas tank towards the middle of the box of the truck.


Ther is no PCV valve on a 06 silverado with a 4.3L engine


The PCV valve is found in the valve cover on the passenger side.



Drivers side valve cover towards the firewall.


It is stuck in a rubber hose and pushed in the top of the valve cover


The EVAP purge valve is located on the engine and the EVAP vent valve is found close to the fuel tank on your 2000 Silverado.



NO. The transmission in that truck is electronic. They STOPED using a modulator valve back in the late 80s.


The MAP (Manifold Absolute Pressure) sensor on a 2003 Silverado truck can be found on the manifold valve cover. Depending on the size of the motor, it will be in the back or near the middle in the top of the valve cover.



The most common cause of that is a bad EGR Valve.


depending on the motor, in all likeliness it is gong to be on the front of the engine to your right, just under the motors left valve cover.



disconnect the hose and remove 2 bolts.


It is in the middle between the intake and the water pump.


on the dryer on the left hand side of the hood. start with 1 can drive and add no more than 2 cans there are two hoses one small one big it is the big hose you put the freon in.


I have an 01 Chevy 5.3 single cab short bed 4x4. The PCV valve is on the back of the left valve cover.


Drivers side valve cover all the way in the back near the firewall


That year truck does not have a modulator valve on the transmission. it has a electronic transmission in it.


Where is the vent vale solenoid on a 2006 Chevy silverado 1500 4.8 L


Connect the freon can and a gauge to the low side AC port. With the AC on high and the engine running, open the freon valve. When the gauge reads full turn the freon off and unhook the gauge.


It is right after the 4th spark plug on drivers side



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.