The pump is on the bottom of the waher bottle a bugger to change..
under bonnet behind windscreen washer bottle inside the black heater motor box you need to take wind screen bottle and arm atture to get at it
its the same bottle as the one for the front screen washer located under the bonnet.
bottom of the washer fluid bottle
neglected to state the year of your Jeep. But check the bottom of the washer bottle. Most cars nowdays have it built into the bottom of the bottle.
motor broke are blocked jets Have you checked the washer fluid level lol
it's behind the washer bottle
It may be that the pump has quit. Have someone get in the vehicle and hit the washer and listen at the bottle for the pump motor to work. If nothing, replace pump motor.
There is a pump motor in the bottom of the washer bottle that pushes the fluid. Check to see if it might be dead.
As long as it comes of the same type of engine out of a citroen saxo, it will fit the peugeot 106
The blower motor resistor is located under the hood, in the right hand cowl, behind the windshield washer bottle.............
On a UK car it is behind the driver's side front body panel. I had to partly remove the front bumper and the panel to replace it.
Hi there hope i can be of assistance. Ok the washer motor itself will be located at the bottom of the washer bottle. You usually need to remove the under-bumper trim, and inner wheel arch trim to expose the motor. The motor is a simple push fit into the washer bottle. Once the motor is located, unplug the electrical connector. Have an assistant turn on the ignition then work the wash jet switch. With your meter check for 12v to the motor. Its a really basic system, one live, one earth. Anywhere above 11.3v is acceptable. If you get 11.3 volts or higher, then the pump has failed. If you get lower, intermittant, or no voltage, then the fault is likely to be with the stalk switch. Thanks Bob