its in the midle of the head under the powerstering pump you have to remove the timing covers if you are going to change it i would recomend the you changethe the timing chain
Ignition power control is located on the intake driver side next to intake motor control looks like small module black color. This is for 95 diamante with 3.0 SOHC engine.
72 Liters, or 19 U.S. Gallons
It is at the back - look for the accelerator cable connection follow it thru and the adjusting screw is on the opposite side
It is quite easy to find. Stand up in front of the car. Either Soch or Doch engine, 3.0 L, it is located in the right-end, almost-top of front engine, nearest to radiator.
If your Diamante is the Dohc 6 cyl. motor in it then you have to remove the entire intake manifold to replace the back 3 plugs I did it in about 4 hours with not many tools and I am a female. So it can be done.
It is located internally inside the Distributor
The thermostat on a 1995 Mitsubishi Montero can be found by following the radiator hose. It is near where the hose enters the engine.
NO, they are programmed differently.
Inside the distributor
No - not unless you are running the A/C. One fan is for the engine and one is for the A/C. Each has its own temp. sensor.
The sensor is most likely located about the middle of the vehicle jsut in front of the Cat converter. The wire comes up through the vehicle and connects in the center console under the carpet and just nfront of the shifter. There may also be another sensor located just off the headers under the hood.
It is on the passenger side beneath the rocker panel.