Mercury Grand Marquis

Where is the wiring harness for the tail lights located on a 2003 mercury grand marquis?


Top Answer
User Avatar
Wiki User
2011-12-11 03:37:05
2011-12-11 03:37:05

There is a lights control box under your steering wheel.


Related Questions

How do you turn on dash lights 1993 mercury grand marquis

where is the fuse for tail lights in 1988 mercury grand marquis

Turn on headlights/parking lights and adjust dimmer control

where you turn on the headlights ... push the button

No good answer check and see if someone has installed trailer lights harness on your car these can short your circuit out hope this helps

Mercury Grand Marquis for one and I am sure there are others that I am not familiar with

change the brake lights check the fuse check the brake light swtch

In the fuse panel, located under the dash, driver's side.

no lights only hige beams if i hold handle up

If your headlights work, but your tail lights don't, your bulbs could be blown. It is possible that you have a shortage in your car.

it is called lights control module box.It is under the sterling wheel.

It's one of two switches located on the Break Pedal. One controls the Brake Lights and the other controls the Speed Control. Hope this helps

check your brake lights if they not worhing replace fuse or brake light switch

It has 2 flasher relays. One for the turn signals and one for the hazard lights. The turn signal flasher is located on the drivers side, under the dash, driver side of steering column, mounted in the fuse panel.

Auto accents in lakewood n.j has all opera lights kits

If your tail lights and dash lights do not come on and the fuses are not blown it more than likely is the headlight switch.Dashlights and taillights on differant fuse.Just put one in my car Sat.

You need to be more definitive. It sounds like it is in your remote settings at the switch, or a loose connection.

below the fog lights there is one on each side

The daytime running lights module on a 2000 Grand Marquis is located in the passenger side engine bay. It lays between the battery and the heater blower.

Answer- just replaced headlight switch on 1993 merc.grd.marq. took care of no tailights, no dash have a bad ignition switchOR, the wiring behind the headlight switch assembly might be bad, the harness can have warped or cracked and/or the wires may have come loose or otherwise lost their connection. Inspecting the wiring for the headlight switch would be the first step if it only occurs when you want the headlights or parking lights on, and the headlamps work but not the gauge cluster lights nor the tail lights, BUT, the brake lights still work.

I have a 1996 Grand Marquis. If one of the brake lights goes out the signal on that side flashes faster. I would check the brake/tail lamps.

Check your local parts house. You should be able to pick up a wire harness to plug in to you vehicles harness. Alot easier then cutting wires. Check with rental companies. Ryder-budget some will sell the harness also.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.