The wire in question is not called a reset but a "Bypass Wire" . It is a single wire with a quick disconnect found right next to the main harness entering the computer module . The bypass wire is used when setting the base ignition timing to 0* . You will not be able to properly set timing with the control wire connected .
its under the glove department. and if its like my blazer under the little shelf like thing under the glove department.
Look under the dash for a single wire connector right side under the glove box.
I have a 1997 Chevy Blazer 4DR and the relay is located underneath the glove box.
The ECM on a 1992 S10 Blazer is located below the glove box.
I believe it is in your glove compartment there is an access to your flasher.
Remove you glove box. It should be behind it.
There should be a single wire hanging below the glove box. disconnect to time. dont forget to reconnect
There's a relay access in the back of the glove compartment.. it'll be one of them.
Behind the passenger side kick panel or behind the glove compartment.
Either in the glove box, under the glove box or on the passenger side of the firewall (the first relay on the left if facing the engine).
Don't know for sure but was told it's behind the glove compartment.
Don't know for sure but was told it's behind the glove compartment.