how about instead of cutting a hole you rent rack time and drop the gas tank down instead it's easier and alot safer then sparking an explosion by cutting a hole in it DON'T cut a hole in your car...it won't come out...take the exaust off, unbolt the differential, and REMOVE the tank...believe me, it's the best way...
Pop the trunk, pull back the trunk liner, remove the 5 plastic screws/wingnuts, and separate light assembly from the car, remove the bulbs and replace.
you have to acess it from inside the trunk drive safe
yes. OR drill a hole in the trunk floor above the tank.
If the key under the rear license plate doesn't work, then you will need to cut the plastic inside the trunk to manually release the lock.
NO But you might take the bottom of the back seat out and there could very well be a round plate there to remove. I've seen it before its worth a try.
THERE SHOULD BE AN ACESS HOLE IN THE TRUNK TO GET TO THE FUEL PUMP THAT IS LOCATED IN THE TRUNK.REMOVE FUEL PUMP AND REPLACE WITH NEW PUMP.
the ACC fuse powers the lighter, the door locks and the trunk hatch. It is a 20amp fuse.
* Remove the trunk lid latch * Detach the lock release box from the latch assembly * To detach the lock cylinder from the trunk lid pry off the retainer
open trunk and remove interior trim. remove five plastic nuts then pull out light assembly. depress the clip and twist the bulb holder counterclockwise and pull out. remove bulb and replace,and reinstall.
There is no trunk release on a 1991 Chevy Caprice.
open trunk,pull back inside lining to trunk,there should be 3 or 4 plastic nuts to take off. then pull out light assembly.
how do i replace a trunk lock with another lock that has a key