rent a snap on mt-2500 from spunrod.com
The timing is set with the aid of a scan tool. It can not be done with a timing light.The timing is set with the aid of a scan tool. It can not be done with a timing light.
It is set to 0 deg. with a scan tool. It can not be done with a timing light.It is set to 0 deg. with a scan tool. It can not be done with a timing light.
The distributor is set to 0 degrees with a scan tool. It can not be done with a timing light.The distributor is set to 0 degrees with a scan tool. It can not be done with a timing light.
The distributor is set to 0 deg with a scan tool. It can not be done with a timing light.The distributor is set to 0 deg with a scan tool. It can not be done with a timing light.
It is not timed with a timing light. It is set to 0 deg with a scan toolIt is not timed with a timing light. It is set to 0 deg with a scan tool
A scan tool is required. The distributor is "zeroed" with the aid of the scan tool. This can not be done with a timing light.A scan tool is required. The distributor is "zeroed" with the aid of the scan tool. This can not be done with a timing light.
The distributor is set to 0 degrees with the aid of a scan tool. it can not be done with a timing light.The distributor is set to 0 degrees with the aid of a scan tool. it can not be done with a timing light.
The timing chain is set by lining up the marks.The distributor is set to 0 degrees with the aid of a scan tool. It can not be done with a timing light.The timing chain is set by lining up the marks.The distributor is set to 0 degrees with the aid of a scan tool. It can not be done with a timing light.
It is set to 0 degrees with a scan tool.It is set to 0 degrees with a scan tool.
It is set to 0 deg. with a scan tool. It can not be done with a timing light.
It is not timed with a timing light. It is set to 0 deg with a scan tool.
The timing on a 1997 Dodge Ram is not set with a timing light. The distributor rotor is lined up with the mark on the pick up plate when the engine is at tdc to set base timing. The timing is then fine tuned with a scan tool. The scan tool is used to set it exactly to 0 degrees.