in number 1
follow first wire on drivers side at front of engine to cap
what is the plug wire placement on the distributor cap of a1996 gmc 4.3 v6?
To set the distributor cap on a 1966 Buick Skylark with a 300 V8, first ensure the engine is off and the ignition is disconnected. Remove the old distributor cap and align the new cap in the same orientation, ensuring the rotor points to the correct cylinder wire terminal. Secure the cap in place with the clips or screws, and reconnect the ignition. Finally, double-check the wire connections to ensure they match the firing order.
green
That is the location of wire #1
The coil wire runs from the coil to the center of the distributor cap.The coil wire runs from the coil to the center of the distributor cap.
The distributor cap is located on the top of the distributor on a 1996 Sunfire. It is connected to the spark plugs via a wire.
To replace the distributor wire on a Toyota Previa, first ensure the engine is off and cool. Disconnect the negative battery terminal to prevent any electrical issues. Remove the distributor cap by unscrewing it and gently pulling it off. Then, detach the old wire from the distributor and the ignition coil, and replace it with the new wire, ensuring a secure connection before reassembling the cap and reconnecting the battery.
A distributor cap holds all the wires, A coil only has 1 wire in the top of it.
The marked # 1 position on the distributor cap faces to the FRONT
where is number one on a vortex 4.3 v-6 distributor cap
First unhook the battery. Next, remove the distributor cap and unhook the wire that runs to the coil. Then loosen the distributor clamp (10mm nut) and pull the distributor out.