0
Add your answer:
Earn +20 pts
What would cause a ceiling fan's lights and fan to stop working while the small LED on the wall switch still lights when it is switched on?
That led is only showing that there is power to the switch and/or the light and fan fixture. You would have to check the power at the fixture to determine if it is actually in the switched feed or the fan/light assembly.
Where is the best place to hang a ceiling fixture?
The best place to hang a ceiling fixture would depend on the room you are putting it in. For example in the dining room you would want to center it over your table. Living rooms and bedrooms usually will be in the center of the room.
How do you replace dining room light fixture?
If you don't know how to install light fixture, I don't recommend that you do it by yourself. The installation theory is actually very simple - all you need to do is attach fixture on the ceiling (or any other place) and then connect the electrical wires (usually there are two of them). After that it's good to put the light cover over the fixture to improve the appearance.
Where would one be able to purchase a fluorescent light fixture for one's home?
Fluorescent light fittings can be found in most DIY stores and builders merchants such as Do It All, Wickes, Homebase and B&Q. They can also be found online at Screwfix and Amazon.
What would cause loss of power to the wires in the ceiling for a light fixture if the breaker is not tripped?
Bad ground connection. Corrosion on wire. Broken or cracked wire. Bad Switch. Mouse chewed through wire. just a guess but it may be faulty wiring in the fixture itself you can try to figure it out first try to problem solve it.did you replace an older one?is it a new fixture?did it work before or after you replaced it?andis it a fairly old one?you can replace it as a last resort.
Where would one be able to purchase a ceiling fan light?
One could purchase a ceiling fan light at a home improvement store, such as Lowe's or Home Depot. Other places where one may purchase a ceiling fan light would be at specialty lighting stores or a manufacturer website.
How do you convert a 6 inch can light into a 3 inch can light fixture?
Recessed Lighting Fixture Cans are manufactured to accept certain types of trim for the type of Recessed Rough in "Can". Check with the manufacturer of the recessed "can" to determine if the rough in "can" will accept the desired 3" light fixture. If not, then the existing 6" Recessed Lighting Fixture "Cans" will need to be removed and replaced with the 3" can in order to accept the desired trim. If the "cans" have been covered by the ceiling installed making them difficult to remove and replace the existing 6"cans and install the proper 3"cans, then you can purchase what is called old work or renovation Recessed Lighting Fixture cans and install them in place of the 6" cans. Some work to repair the ceiling would then be required.
What would cause a ceiling fan's lights and fan to stop working while the small LED on the wall switch still lights when it is switched on?
That led is only showing that there is power to the switch and/or the light and fan fixture. You would have to check the power at the fixture to determine if it is actually in the switched feed or the fan/light assembly.
Where is the best place to hang a ceiling fixture?
The best place to hang a ceiling fixture would depend on the room you are putting it in. For example in the dining room you would want to center it over your table. Living rooms and bedrooms usually will be in the center of the room.
How do you replace dining room light fixture?
If you don't know how to install light fixture, I don't recommend that you do it by yourself. The installation theory is actually very simple - all you need to do is attach fixture on the ceiling (or any other place) and then connect the electrical wires (usually there are two of them). After that it's good to put the light cover over the fixture to improve the appearance.
What does the electrical terminology of the word - fixture - mean?
"Fixture" generally refers to things permanently attached to the structure. A light fixture would be one example, screwed to the wall or ceiling. The light fixture, also called a luminaire, would include devices for holding the lighting elements, supplying electricity to them, enclosing the connections for safety, and means for attaching it to the electrical supply permanently. A "fixture" could, in theory, dangle from a cord permanently attached to a suitable support. For contrast, a cord-connected device would not be a fixture. In fact, it is often illegal to use cord and plug on any appliance that is permanently attached (e.g., screwed in or with water pipes attached).
How do you replace a fan's light bulb?
It depends on the type of fan, whether it is a range hood, bathroom fan, or room ceiling fan. There are several ways they are mounted as explained below. Preferably the power to the fixture in question should be off. 1. If there are thumb screws near the cover (mainly on range hoods and some light only ceiling fixtures), you would remove them. Then you would unscrew the old bulb and screw in the new one. Then you would put the thumb screws back in. 2. This may be just for a light-only fixture, but if the fixture is recessed and the cover is almost completely flush with the ceiling, you would pry it from the ceiling. Then you would replace the bulb. Getting the reataining springs back in may be tricky, and you would need to protect your eyes from debris up in the ceiling. 3. With most bathroom fans that use a square acrylic light cover, you would press into each side and pull it loose. Then you would replace the bulb and snap the cover back on. 4. If you mean a standard ceiling fan, it depends. For most, you would simply unscrew the old bulb and screw a new one in. For others, there are retaining screws holding the globe on, and for a few, the globe unscrews. 5. For a few ceiling fans, you don't replace the bulb, but replace the entire lamp kit. To do that, you remove the 3 screws from the plate above the light kit to drop it down, then disconnect the wiring (cap off the wires from the fan until you are finished), remove the light kit from the plate by loosening the nut. Then follow the instructions with the new light kit and undo the previous steps to reassemble the lower part of the fan with the new light kit.
How would I install a ceiling light?
You would install a ceiling light by first reading the instructions listed in the packaging. You would then buy the right voltage of lighting and install.
Stunning Ceiling Light?
When the sun starts to set in the evening and shadows make their way into living rooms everywhere, lights are turned on to dispel the darkness. The type of lighting used in each home across the country can be nearly as varied as the sands of the sea, given the options available today. Some people prefer to have a lamp of some sort sitting on an end table near the couch or a favorite chair. That style does give a certain feel to the living room or family room. But other people make the choice to have lighting installed on the ceiling instead. The end result is that more light is shed over a greater area by using the ceiling light. There is practically no limit to the varying styles of ceiling lighting available. Flush mount lighting will allow the lighting fixture to sit flush with the ceiling. That creates a very smooth, even look which is very eye appealing. For a room with a very low ceiling, this can be an ideal choice for that situation. This style also does fine in a bathroom setting or in a kitchen setting, as well. There is always the option to choose track lighting. This type of ceiling light allows for the lighting to cover a longer length of the ceiling than a single fixture ceiling light does. This is a good choice of lighting if several people want to have direct lighting above their heads at the same time, perhaps for reading purposes. Then of course, there is always the time proven traditional ceiling light that offers elegance and style. The choices for the traditional light fixture range from a clear glass or etched glass all the way to a French country or a bronze or a brass fixture. One could literally say that the sky is the limit. Or perhaps it would be better to say that the ceiling is the limit when it comes to beautiful ceiling light.
Why would someone choose ceiling track lighting over other types of lighting?
Ceiling track lighting is used over other types mainly for decoration of the light fixture or source. Track lighting is popular as the lights can be pointed in various directions to accent artwork. It is personal preference to use either lighting source.
Where would one be able to purchase a fluorescent light fixture for one's home?
Fluorescent light fittings can be found in most DIY stores and builders merchants such as Do It All, Wickes, Homebase and B&Q. They can also be found online at Screwfix and Amazon.
How do you get the light bulb into the long tube light fixture over bath sink electrician put up lamp and then I said I would put in bulb after painting and now i tube is too long?
Get the right lamp or get the right fixture. Do not attempt to modify the fixture to fit the lamp.
