You will need a tool called a puller to remove your crankshaft on your Nissan Xterra. You can purchase this toll at most auto parts stores, or borrow one from a shop or another mechanic.
check the alignment of the axle and tires take it to a shop and see if they can see
The cost to replace a timing belt can vary from $60 to $200+. The cost depends on shop prices if it will be done in a shop, the brand and price of the belt.
The shop manual says 5-3/8 quarts with a filter change, 5-1/8 quarts when not replacing the filter.
You have a certified shop do a system performance test, unless you know how to perform such a test yourself with a manifold gauge set.
Nissan is a Japanese automotive manufacturer. A Nissan dealer would usually have a service department, and may have an auto body shop as well. I can't give a clear answer to your question as it depends.
my 2000 Nissan does the same thing havent taken it to get looked at yet, although did put in shop about gas mileage only get 10 to 11 miles really bad ran the fuel cleaner through it helped very little i had asked the question bout the speed and tack going out they didnt give me straight answer of course they want u to put n shop sorry if i find out b sure to let u know hope u do same thank u
the cam position sensor is part of the distributor and cannot be serviced seperately. i had this problem when the check engine light was on, code says Camshaft Position Sensor is bad and also the code for bad Knock Sensor. these problems makes my 2000 Nissan Xterra stall and created knocking noise, after do some research. i called the dealer, they told me i have to replace to whole new distributor, which cost about $400. I call the shop names A.D.S ( Alternator, Distributor, Starter service ) they rebuilt my distributor for less than $100. problem solved. there is a small bearing inside the distributor that was bad........
it can be due to several reasons but it would be best if you take it to a repair shop to get it fixed.
engine size would help. check with your local auto parts shop.
Mopatop's Shop - 2000 is rated/received certificates of: Australia:G
Well, what's wrong with it? If you need to have it resurfaced, you have a shop resurface it.. it's about a $50/$60 job. If there's damage to the flywheel or teeth, it'll have to be replaced.